Krüger & Matz KM0817 - Settings; Setting the Hour; Setting the Alarm; Turning Alarm On;Off

17
Owner’s manual
ENEN
POWER SUPPLY
Connect the power cord to the power supply socket. The device is ready to be used.
SETTINGS
1. Hour
After the power cable is connected to the power supply, „0:00” starts to ash on the
display for a minute. During this period, you can set the time directly. To do this:
1. Keep pressing the up/down buttons to set the hour.
2. Press the PROG button to conrm and set minutes.
3. Keep pressing the up/down buttons to set minutes.
4. Press the PROG button to conrm.
If the setting is not conrmed with the PROG button, it will be saved automatically
after about 2 seconds.
If the time will not be set within the rst minute, you need to enter clock settings to
set the time. To do this:
1. Press and hold the PROG button to enter time format settings.
2. When the value starts ashing on the display, use the up/down buttons to set the
desired time format. Press the PROG button to conrm and set hour and minute.
3. Conrm by pressing the PROG button. The device enters alarm settings (see the
paragraph below).
2. Alarm
1. Keep pressing the up/down buttons to set the hour.
2. Press the PROG button to conrm and set minutes.
3. Keep pressing the up/down buttons to set the minute.
4. Press the PROG button to conrm the hour and enter alarm source settings.
5. Press the up/down buttons to set alarm source: buzzer or radio.
6. Press the PROG button to conrm and enter alarm volume settings.
7. Keep pressing the up/down buttons to set the volume. Conrm by pressing the
PROG button.
Notes:
• If no button is pressed within 10 seconds, the device will automatically save last
setting and return to the clock display.
• Alarm volume gradually increases.
2.1 Turn the alarm on/o
Press the PROG button to turn the alarm on/o (when the alarm is on, alarm icon
is on the display).