Krups 868 - Problems and Causes; Coffee Leaking from Filter Holder; Coffee Does Not Come Out; Steam Does Not Come Out of Steam Nozzle

PROBLEMS AND CAUSES
(Always check if machine is plugged in and if machine is in the proper "On" position.)
Problem:
1. Coffee leaking from filter holder
Cause:
. Filter holder not properly inserted
. Filter holder not pushed in far enough
. Internal gasket is dirty, clean gasket
. Gasket without elasticity, replace
. Coffee powder not cleaned off the edge of the filter holder
Problem:
2. Coffee does not come out
Cause:
. No water in boiler container
. No coffee in filter holder
. Riter clogged up because coffee mixture is too fine or pressed down too hard.
Problem:
3. Steamdoesnot comeout of steam nozzle
Cause:
. No water or not enough water in the boiler container
. Steam nozzle is clogged (see section "Cleaning")
. Perfect Froth attachment is clogged (see section "Cleaning the Perfect Froth")
Problem:
4. Not enough froth when frothing the milk
Cause:
. Perfect Froth attachment touches the bottom of the pitcher
. Perfect Froth tip (see figure 11)is clogged (part A) (see section "Cleaning the Perfect Froth")
. Steam nozzle is clogged (see section "Cleaning")
. Not enough water left in boiler to steam for 45-60 seconds
12