emptied (see figure 7).
THIS WILL REQUIRE YOU TO STAY WITH
THE MACHINE TO EMPTY EACH CUP AS IT
BECOMES FULL. UPON COMPLETION OF
EACH CUP RETURN TO THE “0” POSITION!
Step 1
l
Fill the water container with fresh, cold
water (see figure I-3).
While making espresso, water can be
added to the reservoir by opening the
hinged water chamber lid and adding
water to the water reservoir, using
another receptacle to fill the container,
Otherwise, the water reservoir can be
removed and taken to the faucet.
L”rl
CAUTION:
IF THE WATER RESERVOIR IS EMPTY AND
THE PUMP IS RUNNING, YOU WILL HEAR A
VERY DISTINCT NOISE, WHICH IS LOUDER
THAN THE NORMAL OPERATING SOUND. IF
THIS HAPPENS, TURN THE MACHINE
“OFF”. CHECK WATER RESERVOIR AND
REFILL AS NEEDED.
NEVER LET THE PUMP RUN WHEN THE
WATER RESERVOIR IS EMPTY AS THIS
CAN DAMAGE THE PUMP.
Prewarming Espresso/
Cappuccino Cups
If the machine is being used for the first
time during the day, we recommend
prewarming your cups with hot water (see
figure 8). After you have made several
cups of espresso, the cups can be
prewarmed on the warming plate
(b)
of
your Espresso Novo 2000 Plus.
J
Step 2
l
Make sure the control dial is set to
“0”
position. Then switch the appliance “ON”
using the “ON/OFF” switch. Both
indicator lights will illuminate (yellow and’
red). When the yellow indicator light goes
out, the machine is ready for use.
Step 3
Remove filter holder from the appliance.
Choose the desired filter basket which is
required for making one or two cups of
espresso and insert filter holder
(see figure 9).
Depending upon which filter basket you have
chosen, add one measuring spoon of
espresso coffee for each cup of espresso
that you are preparing
(see
figure 10).
l
The one cup filter basket only requires
one
lecel
KRUPS measuring spoon of
espresso coffee.
l
The two cup filter basket only requires
two KRUPS measuring spoons of espresso
coffee.
Make sure that you do not overfill the filter
basket, and that you use the measuring
spoon
Im)
to press your coffee to the proper
consistency for brewing
(see
figure 11).
It is also very important that you remove any
coffee that might have fallen onto the rim of
the filter holder, while you were filling or
tamping the coffee
(see
figure 12).
Insert filter holder back into the machine by
raising it up at a 45 degree angle and turning
it to the right. Turn the filter holder to the
right, until it is firmly locked into place. The
marking located on the center of the filter
holder handle must be within the
“lock-
range” indicated on the lower edge of the
front panel (see figure 13).
Place a cup which has at least a
2-2,5
oz.
capacity underneath the filter holder spout. If
you are preparing more than one cup of
IO
To Next Page
Loading...
Need help?
General
