Krups 984 User Manual

Grinding spresso Beans
If you choose to grind your own beans we
recommend using the KRUPS II Barista #220
grinder. Remember, espresso requires a much
finer grind than regular coffee.
We recommend that you get familiar with all
the parts of your “Espresso Novo 2000 Plus”
before operating the machine. Insert the filter
holder into the machine, and remove and
replace water reservoir. Wipe off the steam
nozzle and Perfect Froth attachment with a
damp cloth to make sure all dust particles
from transport are removed. Wash all loose
parts in warm, soapy water, rinse thoroughly
and dry.
When using your “Espresso Novo 2000 Plus”
for the first time we recommend running
water through the machine to remove any
dust particles which may have settled during
shipping.
Make sure before you start that the
removable overflow grid (g) is properly in
place and that the drip tray (h) is properly
inserted.
Before plugging the appliance into an
electrical outlet, make sure that the control
dial (c) is in the “0” position and the
“ON/OFF” switch (I) is in the “OFF” position.
Step 1
l Open the water chamber lid and remove
the water reservoir (see figure 1). This
allows you to conveniently bring the
water reservoir to the faucet.
l Fill the water container with fresh, cold
water just below the hinge of the handle
(see figure 2).
l Insert the water container back into the
appliance (see figure 3). Make sure that it
sits in properly so the valve on the base
of the water reservoir is activated. The
front view water level indicator tells you
how much water you have added (see
figure 4).
l Insert filter holder with either the one or
two cup filter basket inserted. Raise the
filter holder up into the mach’ine at a 45
degree angle (see figure 5). Turn the filter
holder to the right until the marking
located on the center of the filter holder
handle is within the “lock-range” indicated
on the lower edge of the front panel. This
will lock the filter holder into place. Now
you are ready to warm up your Espresso
Novo 2000 Plus.
Step 2
l Place a large cup that has at least a 5 oz.
capacity underneath the filter holder spout
(see figure 6).
l Turn the “ON/OFF” switch to “I” ON. The
two indicator lights, both yellow and red,
will illuminate. As soon as the yellow
(thermostat) light goes out, the machine
is heated up and ready to use.
l Turn the control dial to the
I rp 11
position
and allow cup of water to run through the
machine. Repeat this process until half
the water in the water container has been
9

Krups 984 Specifications

General

Brand	Krups
Model	984
Category	Coffee Maker
Language	English