To carry out a cleaning program, you will need a container with a capacity of at least 20 oz and KRUPS XS 4000 cleaning
liquid (36).
Turn the cappuccino system’s lid button to the position CLEAN (25).
You can start the cleaning cycle by pressing the button PROG
Maintenance Cappuccino cleaning.
Follow the instructions on the screen.
To disassemble the system, follow the following instructions:
Remove the exible pipe from the jug opening and the drinks outlet (37).
• Unlock the system from the machine (38).
• Remove the accessory cassette (39).
• Remove the black silicone body of the cassette (40).
• Remove the air nozzle: this is the piece located above the black silicone body (41). To clean this part thoroughly, rinse the
exible area while pinching it (42). Leave it to soak in hot water and some dish detergent, then rinse.
• Remove also the plastic piece (43).
The cappuccino system is now completely disassembled (44).
• Take the disassembly key (45).
• Unscrew the end of the steam nozzle (46).
• If necessary, unblock using the needle provided for this purpose (47).
You can also remove the milk inlet pipe together with the lid setting button (48).
Once the elements have been cleaned with warm water and dried, put them back in place and replace the cassette on the jug.
General maintenance
Always remove the main power cord from the wall outlet and allow the appliance to cool before cleaning it.
Do not use utensils or products likely to scratch or corrode the appliance.
Wipe the outside of the appliance with a damp cloth.
Rinse the water tank with clean water.
These parts are not dishwasher safe.
CAPPUCCINO SYSTEM CLEANING
MANUAL MAINTENANCE OF THE CAPPUCCINO SYSTEM
9
To Next Page
Loading...
