KRUPS SERIE EA90
38
9
n Replace the two drip trays (see visuals p. 13).
n The manual steam nozzle cleaning cycle is finished.
n Press OK to confirm and quit.
Caution: The manual cleaning of the nozzle and the cleaning container must be carried out in this
sequence: If not, you risk damage to the steam nozzle assembly, malfunction or breakage.
!
6
n The steam tube moves down.
n You can thus clean it properly with a damp cloth (you can use a little
washing-up liquid, but rinse it thoroughly). The steam tube cannot be
dismantled.
n Press the “OK” button. The steam tube moves up so that the nozzle tip
and the nozzle can be refitted.
7
n Re-screw the nozzle with the tip onto the steam tube.
n Press the “OK” button.
n The steam nozzle assembly moves up and stops above the cleaning
container.
8
n Cleaning the steam nozzle cleaning container (11).
n Press YES to the question: “Do you want to clean your cleaning container?”
if you want to clean it.
n Press the top of the container to remove it. Clean it under running water.
n To put the container back, first position the lower part and then press the
upper part: you should hear a “click”.
n Press the “OK” button.
hh
IFU_EN_KR_COFFEEMAKER_8020000082.qxp_Mise en page 1 22/05/2017 17:22 Page38
To Next Page
Loading...
Need help?
General
