10
A UTOM ATIC SCALE REMOVAL PRO GRAM – TOTAL DURATION: ABOUT 22 MINUTES
T
he quantity of scale deposited depends on the hardness of the water used. The appli a nc e w il l a ut o ma t ic al l y w ar n y ou wi th a
mess
age when you need to proceed with scale removal.
T
o perform the cleaning program, you will need a recipient with minimum capacity of 0.6 litres and a K RU PS F 054 (40 g)
cleaning s
achet.
The scale removal program is in three parts – the scale removal cycle itself, then 2 rinsing cycles.
Press to perform cleaning at any time and then choose MAINTENANCE => OK => SCALE REMOVAL from the
menus displayed.
Caution! To benefit from the warranty conditions, it is essential to perform the appliance scale
removal cycle when the appliance tells you to do so. Be sure to follow the order of operations.
Y
ou can continue to use the appliance but you are advised to perform the operation as soon as possible.
Press the key to st a r t t h e a u t o m a t i c
cleaning program when the “Scale removal
needed” message is displayed.
Clean the cleaning tray
, the drip
tray, the coffee grounds collector
and the drip tray grid with hot
water and a liquid detergent.
Rinse the water t
ank
with fresh water.
Only use KRU PS scale removal products, citric acid or tar taric acid. You can obt ain scale removal products from
KRUPS Service Centres. In no event must you use conventional starchy sulphonic acid or other products containin g
that acid.
The manufacturer may not be held responsible for damage to the appliance through use of other products.
Be sure to complete the entire scale removal cycle to avoid any risk of intoxication.
The scale removal cycle is a discontinuous cycle. Do not put your hands under the coffee outlets during the
cycle.
Make certain to protect your work surface during scale removal cycles, especially if they are made
of marble, stone or wood.
Just follow the instructions shown on the
screen, making sure the s achet dissolves
fully.
If the coffee grounds collector is not fitted you will be warned by a mess ag e be ing disp laye d. F it t he c olle ctor
again for the cycle to continue automatically.
If a power failure occurs during the cycle, you will have to st art it a gain righ t fr om th e be ginni ng. You will not be
able to postpone this operation.
GENERAL MAINTENANCE
Always remove the power supply cord from the socket and let your appliance cool down before cleaning it.
Do not use utensils or cleaning products likely to scratch or corrode the appliance.
Wipe the body of the appliance on the outside using a moist cloth.
If your product is equipped with our Claris - Aqua Filter System cartridge F088 - Please remove this
cartridge during the descaling operation.
To Next Page
Loading...
Need help?
General
