2 Safety
9 of 36
KSB IE3-Motor
▪ Any work on the product shall only be performed when it has been disconnected
from the power supply (de-energised).
▪ Carry out work on the product during standstill only.
▪ As soon as the work has been completed, re-install and re-activate any safety-
relevant devices and protective devices. Before returning the product to service,
observe all instructions on commissioning.
2.9 Unauthorised modes of operation
Never operate the product outside the limits stated in the data sheet and in this
manual.
The warranty relating to the operating reliability and safety of the product supplied
is only valid if the product is used in accordance with its intended use.
2.10 Electromagnetic compatibility
When operating the motor on a frequency inverter always observe the frequency
inverter manufacturer's information on compliance with the Electromagnetic
Compatibility Directive. Take additional measures to ensure compliance with the
Directive and obtain a connection approval from the local energy supply company, if
necessary.
To Next Page
Loading...
General