18
EN
KEYBOARD OPERATIONS
ACTIONS IN STAND-BY MODE
Refer to the keyboard manual to use the ergo capsense keyboard and
get familiar with the functions of its keys and circular scroll
1
.
1
If the keyboard is not confi gured in the system, the keyboard display does not show any
information, and the user PIN is disabled. In this way, login is permitted only through the installer
PIN.
Six operations can be performed while the system is in stand-by mode:
1. Detailed list of information (by pressing the Enter key)
2. Partitions status (by pressing the # key)
3. Zones status (by pressing the
key)
4. Activation of a function (by holding down the corresponding numeric
key for 3 seconds)
5. Entering the PIN (default PIN is 147258)
6. Keyboard lock for cleaning: hold the ESC key pressed for 3 seconds
In stand-by mode, the following informations can be displayed by
pressing the ENTER key:
- If an alarm occurs, it is possible to see which zone is in alarm (if the
notices “without PIN display” is enabled)
- List of armed (if the system activation status display is enabled)
- List of open zones (if open zones real time display is enabled)
- Information about the installer
Use the circular scroll to browse through these lines.
To activate a function (macro) without entering the PIN, keep the
corresponding numeric key pressed for seconds. This function must be
enabled by the installer.
To Next Page
Loading...
Need help?
General
