20
EN
The lower line of the display shows pieces of information that can be
tailored by the installer on each keyboard:
1. Date and time
2. System activation status (On or Off)
3. Outdoor temperature (requires at least an imago BUS outdoor siren)
4. Indoor temperature (requires at least a radius BUS indoor siren)
5. GSM operator (requires a gemino BUS link)
6. Real-time indication of open zones
NOTE: in the user menu, if no key is pressed within 30 seconds, the keyboard will automatically
return to the stand-by mode.
During programming it is possible to disable the system status display
on the fi rst row when the keypad is in stand-by. In this case, to display
the status of the system, you must enter a valid user PIN or approach a
programmed key to the keypad. with this setting, when the system is
disarmed, on the fi rst row it displays the strings ‘Alerts queued’ or ‘Ksenia
security’ depending of whether there are or there are not anomalies.
When the system is armed it always displays the string ‘Ksenia Security’.
DISPLAY INFORMATION IN STAND-BY MODE
To Next Page
Loading...
Need help?
General
