KTM 1050 Adventure User Manual

16 ELECTRICAL SYSTEM 160
16.9 Changing the low beam bulb
Note
Damage to reflector Reduced brightness.
– Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease before
mounting.
Preparatory work
– Switch off all power consumers and switch off the engine.
– Remove the seat. ( p. 97)
– Remove the front side cover. ( p. 109)
– Remove the tank cover. ( p. 117)
– Remove the mask spoiler. ( p. 111)
– Remove the wind shield. ( p. 121)
– Remove the headlight mask with the headlight. ( p. 158)
S00297-10
Main work
–
Push headlight bulb

lightly into the bulb socket, turn it all the way counterclock-
wise, and pull it out.
–
Unplug connector

.

KTM 1050 Adventure Specifications

General

Displacement	1050 cc
Transmission	6-speed
Fuel Tank Capacity	23 liters
Seat Height	850 mm
Bore x Stroke	103 mm x 63 mm
Fuel System	Electronic Fuel Injection
Cooling System	Liquid cooled
ABS	Bosch 9M+ two-channel ABS
Compression Ratio	12.5:1
Starter	Electric
Engine Type	2-cylinder, 4-stroke
Power	95 hp
Torque	107 Nm
Front Suspension	WP USD, 43 mm
Rear Suspension	WP monoshock
Front Brake	4-piston calipers
Rear Brake	267 mm disc, 2-piston caliper
Frame	Chromium-Molybdenum steel trellis
Front Wheel	19 inch
Rear Wheel	17 inch
Dry Weight	212 kg (467 lbs)