Why KTM Motorcycle engine turns only when clutch lever is drawn?
If the KTM Motorcycle engine turns only if the clutch lever is drawn, the vehicle is probably in gear, so shift the transmission to idle. It's also possible that the safety start system is faulty, so read out the fault memory using the KTM diagnostics tool.
What to do if my KTM 1190 ADVENTURE Motorcycle engine dies during the trip?
If your engine dies while riding, it could be due to a lack of fuel, so refuel. It may also indicate a defect in the fuel injection system.
Why does the engine warning lamp light up or flash on my KTM Motorcycle?
The engine warning lamp illuminates due to a defect in the fuel injection system.
Why does my KTM 1190 ADVENTURE have high oil consumption?
High oil consumption can be attributed to a couple of reasons: The engine oil level may be too high, so check it. Alternatively, the engine oil might be too thin (low viscosity), so change the engine oil and filter, and clean the oil screens.
What to do if KTM 1190 ADVENTURE Motorcycle engine turns even when a gear is engaged?
If the KTM Motorcycle engine turns although a gear is engaged, the safety start system is faulty, so read out the fault memory using the KTM diagnostics tool.
Why does KTM Motorcycle engine only turn with the clutch lever pulled?
If the KTM Motorcycle engine only turns when the clutch lever is drawn, make sure the transmission is in idle.
What does it mean if my KTM Motorcycle engine turns although a gear is engaged?
If the engine turns even when a gear is engaged, this indicates a faulty safety start system.
What to do if my KTM Motorcycle engine does not crank when pressing the electric starter button?
If your KTM Motorcycle engine doesn't crank when you press the electric starter, several things could be the cause. First, make sure the emergency OFF switch is in the ON position. You might also need to follow the correct start procedure. Also, check if the battery is discharged and recharge it if necessary and check the quiescent current. Other potential problems could be a faulty safety start system, disabled ICU, or CAN bus communication error. In these cases you need to read out the fault memory using the KTM diagnostics tool. Also, a fault in the EFI or MCU control unit can cause this problem, and you need to read out the fault memory using the KTM diagnostics tool.
What to do if KTM 1190 ADVENTURE Motorcycle engine dies while riding?
If your KTM Motorcycle engine dies during a trip, it could be due to a lack of fuel, so refuel. Another potential cause is a defect in the fuel injection system.
What causes high oil consumption in a KTM 1190 ADVENTURE Motorcycle?
If your KTM Motorcycle has high oil consumption, it could be because the engine oil level is too high, so check the engine oil level. It could also be that the engine oil is too thin (low viscosity), so change the engine oil and oil filter and clean the oil screens.
Defines the intended operational use of the KTM motorcycle.
Provides general safety instructions and highlights important warnings.
Explains different levels of danger and their associated symbols.
Provides crucial guidelines for safe operation, including hazards.
Emphasizes the importance of wearing appropriate protective clothing.
Highlights the importance of proper service and maintenance for longevity.
Explains where to find the chassis number on the vehicle.
Indicates the location of the engine number stamped on the engine.
Covers the combination switch and its functions like light, hazards, signals.
Details the emergency OFF and electric starter buttons.
Provides an overview of the instrument cluster components.
Describes the matrix display and its control via the menu switch.
Details the elements shown on the segment display.
Lists and explains the various indicator lamps on the instrument cluster.
Explains how messages are displayed and confirmed on the matrix display.
Introduces the menu system for the matrix display.
Details the Motorcycle Traction Control and ABS settings.
Covers different riding modes like Sport, Street, Rain, Offroad.
Offers essential advice for the initial use of the motorcycle.
Provides guidelines for the engine running-in phase.
Gives warnings and advice on loading the vehicle safely.
Lists pre-ride checks and maintenance tasks for roadworthiness.
Details the procedure for starting the motorcycle engine.
Covers gear shifting techniques and general riding advice.
Provides instructions and warnings on using the braking system.
Guides on how to safely stop and park the motorcycle.
Details the procedure and safety precautions for refueling.
Lists mandatory service tasks at specified intervals.
Explains how to adjust suspension damping for different riding conditions.
Details how to set suspension based on vehicle loading.
Explains the procedure for cleaning the motorcycle chain.
Details how to check the chain tension.
Provides instructions for adjusting the chain tension.
Explains how to check and adjust the hydraulic clutch fluid level.
Details how to check for play in the steering head bearing.
Explains the ABS system, its functions, and limitations.
Provides instructions for checking brake disc wear and condition.
Explains how to check the front brake fluid level.
Describes how to check the thickness of the front brake linings.
Explains how to check the rear brake fluid level.
Describes how to check the thickness of the rear brake linings.
Step-by-step guide for removing the front wheel.
Step-by-step guide for installing the front wheel.
Step-by-step guide for removing the rear wheel.
Describes the different riding modes affecting engine and traction control.
Explains the function and control of the motorcycle traction control system.
Provides instructions on how to check the engine oil level.
Details the procedure for changing engine oil and filter.
Lists detailed technical specifications for the engine.
General| Engine Type | 2-cylinder, 4-stroke, V 75° |
|---|---|
| Displacement | 1195 cc |
| Bore x Stroke | 105 mm x 69 mm |
| Torque | 125 Nm @ 7500 rpm |
| Transmission | 6-speed |
| Fuel System | Electronic Fuel Injection |
| Front Suspension | WP USD Ø 48 mm |
| Rear Brake | Single 267 mm disc, 2-piston caliper |
| ABS | Bosch 9ME Combined ABS |
| Fuel Tank Capacity | 23 liters |
| Seat Height | 860 mm |
| Dry Weight | 217 kg |
| Compression Ratio | 12.5:1 |
| Starter | Electric |
| Wheelbase | 1560 mm |
| Ground Clearance | 220 mm |
| Power | 110 kW (150 hp) @ 9500 rpm |
| Rear Suspension | WP monoshock |
| Front Brake | Twin 320 mm discs, 4-piston calipers |
| Frame | Chromium-Molybdenum steel trellis frame, powder coated |
To Next Page