KTM 1190 ADVENTURE User Manual

16 ELECTRICAL SYSTEM 162
16.3 Installing the battery
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
– Keep batteries out of the reach of children.
– Wear suitable protective clothing and goggles.
– Avoid contact with battery acid and battery gases.
– Keep sparks and open flames away from the battery. Only charge in well-ventilated rooms.
– In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least 15
minutes and contact a physician.
Caution
Danger of accidents If the vehicle is operated with a discharged battery or without a battery, electronic components and safety
equipment may be damaged.
– Never operate the vehicle with a discharged battery or without a battery.
M00573-11
Main work
–
Position the battery in battery case

.
Guideline
The even side of the battery case must be opposite the poles.
– Position the battery and battery case in the battery compartment.
–
Position the positive cable

and mount and tighten the screw.
Guideline
Screw, battery terminal M6 4.5 Nm
(3.32 lbf ft)
–
Position the negative cable

and mount and tighten the screw.

KTM 1190 ADVENTURE Specifications

General

Engine Type	2-cylinder, 4-stroke, V 75°
Displacement	1195 cc
Bore x Stroke	105 mm x 69 mm
Torque	125 Nm @ 7500 rpm
Transmission	6-speed
Fuel System	Electronic Fuel Injection
Front Suspension	WP USD Ø 48 mm
Rear Brake	Single 267 mm disc, 2-piston caliper
ABS	Bosch 9ME Combined ABS
Fuel Tank Capacity	23 liters
Seat Height	860 mm
Dry Weight	217 kg
Compression Ratio	12.5:1
Starter	Electric
Wheelbase	1560 mm
Ground Clearance	220 mm
Power	110 kW (150 hp) @ 9500 rpm
Rear Suspension	WP monoshock
Front Brake	Twin 320 mm discs, 4-piston calipers
Frame	Chromium-Molybdenum steel trellis frame, powder coated