What to do if malfunction indicator lamp lights up on KTM Motorcycle?
If the malfunction indicator lamp lights up or flashes on your KTM Motorcycle, it is likely due to a malfunction in the electronic fuel injection. You should check the wiring for any damage and inspect the electrical plug-in connections for corrosion or damage. Also, use the KTM diagnostics tool to read out the fault memory.
Why does my KTM Motorcycle engine overheat?
Your KTM Motorcycle engine may overheat due to several reasons. It could be caused by too little coolant in the cooling system, so check for leakage and the coolant level. Insufficient air stream can also cause overheating, so switch off the engine when stationary. Other potential causes include very dirty radiator fins (clean them), foam formation in the cooling system (drain and refill the coolant), a damaged cylinder head or cylinder head gasket (check them), a bent radiator hose (change it), or a defective thermostat (check it; guideline opening temperature: 70 °C (158 °F)).
General| Displacement | 124.8 cm³ |
|---|---|
| Bore x Stroke | 54 mm x 54.5 mm |
| Starter | Electric starter |
| Transmission | 6-speed |
| Front Suspension | WP XACT-USD, Ø 48 mm |
| Rear Suspension | WP XACT Monoshock with linkage |
| Front Brake | Disc brake |
| Rear Brake | Disc brake |
| Ground Clearance | 375 mm |
| Seat Height | 950 mm |
| Weight (without fuel) | 87.5 kg |
| Cooling | Liquid cooled |
| Front Tire | 80/100-21" |
| Rear Tire | 100/90-19" |
| Front Brake Diameter | 260 mm |
| Rear Brake Diameter | 220 mm |
| Engine Type | Single-cylinder, 2-stroke |
| Frame | Central tube frame made of chrome molybdenum steel |
| Fuel Tank Capacity | 7.2 liters |
Ensures safe operation of the motorcycle, covering rider fitness, ventilation, and hot components.
Highlights the importance of wearing appropriate protective clothing for all rides to minimize injury risk.
Essential advice for new riders, including reading the manual, knowing controls, and adjusting levers.
Guidance on the engine break-in process, specifying performance limits for initial operating hours.
Pre-ride checks covering essential systems like oil, brakes, coolant, chain, tires, and fasteners.
Instructions on proper braking techniques, including force adjustment, brake system checks, and surface conditions.
Step-by-step guide to adjust the shock absorber spring preload for optimal riding characteristics.
Step-by-step guide for replacing worn front brake linings.
Step-by-step guide for replacing worn rear brake linings.
To Next Page
