What to do if malfunction indicator lamp lights up on KTM Motorcycle?
If the malfunction indicator lamp lights up or flashes on your KTM Motorcycle, it is likely due to a malfunction in the electronic fuel injection. You should check the wiring for any damage and inspect the electrical plug-in connections for corrosion or damage. Also, use the KTM diagnostics tool to read out the fault memory.
Why does my KTM Motorcycle engine overheat?
Your KTM Motorcycle engine may overheat due to several reasons. It could be caused by too little coolant in the cooling system, so check for leakage and the coolant level. Insufficient air stream can also cause overheating, so switch off the engine when stationary. Other potential causes include very dirty radiator fins (clean them), foam formation in the cooling system (drain and refill the coolant), a damaged cylinder head or cylinder head gasket (check them), a bent radiator hose (change it), or a defective thermostat (check it; guideline opening temperature: 70 °C (158 °F)).
General| Displacement | 124.8 cm³ |
|---|---|
| Bore x Stroke | 54 mm x 54.5 mm |
| Starter | Electric starter |
| Transmission | 6-speed |
| Front Suspension | WP XACT-USD, Ø 48 mm |
| Rear Suspension | WP XACT Monoshock with linkage |
| Front Brake | Disc brake |
| Rear Brake | Disc brake |
| Ground Clearance | 375 mm |
| Seat Height | 950 mm |
| Weight (without fuel) | 87.5 kg |
| Cooling | Liquid cooled |
| Front Tire | 80/100-21" |
| Rear Tire | 100/90-19" |
| Front Brake Diameter | 260 mm |
| Rear Brake Diameter | 220 mm |
| Engine Type | Single-cylinder, 2-stroke |
| Frame | Central tube frame made of chrome molybdenum steel |
| Fuel Tank Capacity | 7.2 liters |
To Next Page
