What to do if KTM 200 Duke 2016 engine does not crank?
If the KTM Motorcycle engine doesn't crank when you press the electric starter, it might be due to an operating error. Make sure you are following the correct engine starting procedure. Another possible cause is a discharged battery, which requires recharging. Also, check fuses 1, 3, 4, and 8 and replace any that are blown. Finally, verify that there is a proper ground connection.
General| Displacement | 199.5 cc |
|---|---|
| Transmission | 6-speed |
| Seat Height | 810 mm |
| Tires (Front) | 110/70 - 17 |
| Tires (Rear) | 150/60 - 17 |
| Bore x Stroke | 72 mm x 49 mm |
| Compression Ratio | 11.3:1 |
| Frame | Steel trellis frame |
| Front Suspension | WP upside-down forks |
| Rear Suspension | WP monoshock |
| Rear Brake Caliper | Single-piston floating caliper |
| Wheelbase | 1, 367 mm |
| Engine Type | Single-cylinder, 4-stroke |
| Fuel System | Electronic Fuel Injection |
| Brakes (Front) | Single disc |
| Brakes (Rear) | Single disc |
| Ignition System | Digital ignition |
| Clutch | Wet multi-disc |
| ABS | Optional |
| Torque | 19.2 Nm @ 8, 000 rpm |
| Front Brake Caliper | Four-piston radial fixed caliper |
Defines vehicle use, risk symbols, warnings, and tampering precautions.
Details safe operation practices and the importance of protective clothing.
Guidelines for maintenance work and utilizing the owner's manual.
Explains operation of levers, buttons, and switches on handlebars.
Overview of the instrument cluster, its display, warnings, and buttons.
Procedures for opening/closing the fuel cap and using the seat lock.
Essential steps for initial operation and engine break-in procedures.
Critical pre-ride checks, starting, riding, and braking guidance.
Overview of required service intervals and basic maintenance tasks.
Procedures for wheel/tire removal, installation, condition, and air pressure checks.
Checking ABS, discs, fluid levels, and linings for front and rear brakes.
Procedures for battery, fuse, and bulb replacement.
Procedures for checking and maintaining the cooling system and coolant.
How to check engine oil level and perform an oil and filter change.
Essential specifications for engine, fluids, chassis, electrical, and other components.
Guide to identifying and resolving common motorcycle faults and issues.
To Next Page