Why is the speedometer in the combination instrument not functioning on my KTM Motorcycle?
If the speedometer in the combination instrument is not functioning on your KTM Motorcycle, the speedometer wiring harness might be damaged or the plug-in connection is oxidized. Check the wiring harness and plug-in connection.
What to do if my KTM 200 DUKE EU Motorcycle engine does not crank?
If the KTM Motorcycle engine doesn't crank when you press the electric starter, several issues could be the cause. It might be an operating error, so go through the engine starting steps. The battery could be discharged, requiring a recharge. A fuse (1, 2, 3, or 4) might be blown, necessitating a replacement. Alternatively, there might be no ground connection, which needs to be checked.
Why does my KTM 200 DUKE EU engine have too little power?
If your KTM Motorcycle engine has too little power, several factors could be responsible. A very dirty air filter could be the cause, so you should change it. Another possibility is a very dirty fuel filter, in which case you should check the fuel pressure. There might be too little coolant in the cooling system; check for leakage and the coolant level. Very dirty radiator fins can also cause this issue, so clean them. Other possible causes include foam formation in the cooling system (drain and refill/bleed the system) or a defective thermostat (check the thermostat). Finally, a defect in the fuel injection system could be the reason, so read out the fault memory using the KTM diagnostics tool.
What to do if my KTM 200 DUKE EU engine dies during the trip?
If your KTM Motorcycle engine dies during a trip, it could be due to a lack of fuel; in this case, refuel your motorcycle. Alternatively, a blown fuse (1, 2, 3, or 4) could be the cause; replace the fuses of individual power consumers.
Why is my KTM Motorcycle consuming so much oil?
High oil consumption in your KTM Motorcycle can be attributed to several reasons. The engine vent hose might be bent, so route it without bends or replace it if needed. The engine oil level could be too high, so check it. Also, the engine oil might be too thin (low viscosity), so change the engine oil and oil filter, and clean the oil screen.
Why does the combination instrument show nothing on the display of my KTM Motorcycle?
If the combination instrument shows nothing on the display of your KTM Motorcycle, it may be because fuse 8 is blown. Change the fuses.
Why are the headlight and parking light not functioning on my KTM Motorcycle?
If the headlight and parking light are not functioning on your KTM Motorcycle, it's possible that fuse 6 is blown. In this case, you should change the fuses.
Why does my KTM 200 DUKE EU Motorcycle engine only turn if the clutch lever is drawn?
If your KTM Motorcycle engine only turns when the clutch lever is drawn, it's likely that the vehicle is in gear. Shift the gear to neutral. It could also be that the vehicle is in gear and the side stand is folded out, so shift to neutral.
Why does KTM 200 DUKE EU engine turn only if the clutch lever is drawn?
The KTM Motorcycle engine turns only if the clutch lever is drawn because the vehicle is in gear. Shift gear to neutral. Another possible reason is that the vehicle is in gear and the side stand is folded out, so shift gear to neutral.
Why aren't the headlight and parking light working on my KTM 200 DUKE EU?
If the headlight and parking light are not functioning on your KTM Motorcycle, it might be because fuse 6 is blown. Replace the fuses of individual power consumers.
General| Torque | 19 Nm @ 8, 000 rpm |
|---|---|
| Transmission | 6-speed |
| Tires (Front) | 110/70 R17 |
| Tires (Rear) | 150/60 R17 |
| Frame | Steel trellis frame |
| Bore x Stroke | 72 mm x 49 mm |
| Compression Ratio | 11.5:1 |
| Front Brake Diameter | 300 mm |
| Rear Brake Diameter | 230 mm |
| Ground Clearance | 170 mm |
| Dry Weight | 139 kg |
| Engine Type | Single cylinder, 4-stroke |
| Displacement | 199.5 cm³ |
| Power | 26 hp (19 kW) @ 10, 000 rpm |
| Fuel System | Electronic Fuel Injection |
| Brakes | Disc brakes |
| Cooling | Liquid cooled |
| Rear Suspension | WP monoshock |
| Rear Brake | Single-piston floating caliper, disc brake |
| Power Output | 26 hp (19 kW) @ 10, 000 rpm |
| Starter | Electric |
| Front Wheel | 17-inch |
| Rear Wheel | 17-inch |
Explains the meaning of specific symbols used in the manual for clarity and safety.
Details the typographical formats used in the document for consistent understanding.
Defines the intended use of KTM sport motorcycles for regular road operation.
General safety instructions crucial for operating the vehicle safely.
Explains different degrees of risk (Danger, Warning, Caution, Note) and their associated symbols.
Warns against tampering with the noise control system and related legal prohibitions.
Provides essential safety guidelines for operating the motorcycle responsibly.
Emphasizes the importance of wearing appropriate protective gear for riding.
Outlines rules and guidelines for performing service work on the vehicle.
Discusses responsible motorcycle use and environmental considerations.
Highlights the importance of reading and keeping the owner's manual accessible.
Details terms and conditions related to the vehicle's guarantee and warranty.
Provides information on the correct operating and auxiliary substances for the motorcycle.
Advises on using only approved spare parts and accessories for safety.
Stresses the importance of proper service and tuning for optimal operation.
Notes that figures in the manual may depict special equipment or be simplified.
Information on how to contact authorized KTM dealers for assistance.
Illustrates and labels the front left view of the motorcycle.
Illustrates and labels the rear right view of the motorcycle.
Details the location of the chassis number and type label on the motorcycle.
Indicates where to find the engine number stamped on the motorcycle.
Explains where the key number is located for ordering spare keys.
Describes the location and function of the clutch lever.
Details the location and operation of the hand brake lever.
Explains the throttle grip's location and function on the handlebar.
Describes the location and operation of the horn button.
Details the operation of the light switch for low and high beams.
Explains the function of the high beam flasher button.
Describes the operation of the turn signal switch.
Details the function of the emergency OFF switch.
Explains the location and operation of the electric starter button.
Describes the ignition and steering lock functions and operation.
Provides an overview of the motorcycle's combination instrument.
Offers crucial advice and warnings for the initial use of the motorcycle.
Provides guidelines for the engine's running-in phase for optimal performance.
Details safe practices and warnings for loading the motorcycle with baggage.
Lists essential checks and maintenance steps before riding the motorcycle.
Provides detailed instructions and safety precautions for starting the motorcycle.
Explains the procedure for safely starting off from a standstill.
Offers guidance on shifting gears and general riding techniques.
Details correct braking techniques and warnings for safe deceleration.
Provides instructions and safety measures for stopping and parking the motorcycle.
Offers advice and precautions related to transporting the motorcycle.
Provides essential safety information and procedures for refueling the motorcycle.
Outlines the recommended service intervals and tasks for the motorcycle.
Explains how to adjust the rear shock absorber's spring preload for optimal ride.
Details the procedure for adjusting the motorcycle's shift lever.
Instructions for safely raising the motorcycle using a rear wheel stand.
Procedure for safely removing the motorcycle from a rear wheel stand.
Instructions for safely raising the motorcycle using a front wheel stand.
Procedure for safely removing the motorcycle from a front wheel stand.
Step-by-step guide on how to remove the passenger seat.
Instructions for correctly installing the passenger seat.
Details the procedure for removing the main seat.
Provides instructions for mounting the main seat.
Guidance on checking the drive chain for dirt accumulation.
Steps for cleaning the drive chain properly.
Explains how to check the drive chain tension for correct operation.
Provides instructions for adjusting the drive chain tension.
Guidance on inspecting the chain, rear, and engine sprockets for wear.
Step-by-step instructions for removing the front spoiler.
Details on how to install the front spoiler correctly.
Explains the ABS system, its function, and limitations.
Provides instructions and specifications for checking brake disc wear.
Details how to check the front brake fluid level and warnings.
Step-by-step guide for adding front brake fluid safely.
Instructions for checking the minimum thickness of front brake linings.
Explains how to check the free travel of the foot brake lever.
Provides instructions for adjusting the foot brake lever's free travel.
Details how to check the rear brake fluid level and associated warnings.
Step-by-step guide for adding rear brake fluid safely.
Instructions for checking the minimum thickness of rear brake linings.
Step-by-step guide on how to remove the front wheel.
Instructions for correctly installing the front wheel.
Detailed procedure for removing the rear wheel.
Provides instructions for properly installing the rear wheel.
Guidance on inspecting the rear hub rubber dampers for wear.
Instructions for inspecting the condition and tread depth of tires.
Details how to check and maintain correct tire air pressure.
Step-by-step instructions for safely removing the motorcycle battery.
Provides guidance on correctly installing the motorcycle battery.
Explains the procedure for safely recharging the motorcycle battery.
Instructions for changing the fuses related to the ABS system.
Details on how to change fuses for various power consumers.
Step-by-step guide for replacing the headlight bulb.
Instructions for replacing the parking light bulb.
Explains how to check the motorcycle's headlight alignment.
Provides instructions for adjusting the headlight beam distance.
Overview of the cooling system's components and operation.
Instructions for checking coolant antifreeze and level with safety warnings.
Details on checking coolant levels in the compensating tank and radiator.
Provides instructions for draining the cooling system's coolant.
Step-by-step guide for filling and bleeding the cooling system.
Explains how to check and adjust the throttle cable play.
Detailed instructions for adjusting the throttle cable play.
Guidance on checking the clutch lever play for smooth operation.
Provides steps for adjusting the clutch cable play.
Instructions for checking the engine oil level and specifications.
Detailed procedure for changing engine oil, filter, and cleaning oil screen.
Provides guidance on adding engine oil and specifications.
Offers guidelines and precautions for cleaning the motorcycle.
Details necessary checks and maintenance for winter storage and use.
Provides steps and recommendations for storing the motorcycle long-term.
Guides on preparing the motorcycle for use after a period of storage.
Addresses issues where the engine fails to crank when the starter button is pressed.
Diagnoses why the engine only turns over when the clutch lever is pulled.
Troubleshoots common reasons for the engine turning but not starting.
Identifies potential causes for reduced engine power.
Diagnoses issues related to engine overheating.
Explains the meaning of the engine diagnosis warning lamp and potential causes.
Addresses the issue of the engine stopping unexpectedly during a trip.
Troubleshoots reasons for the ABS warning lamp illuminating.
Identifies potential causes for excessive engine oil consumption.
Diagnoses issues with non-functional headlight or parking lights.
Troubleshoots problems with turn signals, brake lights, or horn.
Addresses issues with the time display on the instrument cluster.
Diagnoses reasons for a discharged motorcycle battery.
Troubleshoots a blank display on the combination instrument.
Diagnoses issues with a non-functioning speedometer.
Provides detailed technical specifications for the engine.
Lists essential tightening torques for engine components.
Specifies capacities for engine oil, coolant, and fuel.
Details technical specifications related to the motorcycle's chassis.
Lists technical data for the motorcycle's electrical components.
Provides specifications for the front and rear tires.
Details technical specifications for the front fork.
Lists technical specifications for the rear shock absorber.
Specifies tightening torques for various chassis components.
Information on specifications and recommendations for brake fluid.
Details on coolant specifications, mixture ratios, and antifreeze protection.
Information on pre-mixed coolant specifications and supplier.
Specifications and recommendations for SAE 15W/50 engine oil.
Specifications and recommendations for SAE 10W/40 engine oil.
Details on specifications and recommendations for fork oil.
Information on recommended fuel grade and ethanol content.
Recommendations for chain cleaner products.
Recommendations for chain lubricant suitable for road use.
Guidance on cleaning and preserving materials for various motorcycle parts.
Recommendations for fuel additive products.
Recommendations for paint polish products.
Recommendations for long-life grease products.
Recommendations for motorcycle cleaner products.
Recommendations for cleaners and polishes for various surface finishes.
Recommendations for universal oil spray products.
Explanation of the JASO T903 MA standard for 4-stroke motorcycle engines.
Explanation of the SAE viscosity classification system for oils.
To Next Page
