Why KTM 125 Duke EU 2015 Motorcycle engine turns but does not start?
If the engine of your KTM Motorcycle turns but does not start, it could be due to an operating error. Review the engine starting steps. Another possible cause is a fault in the fuel injection system, which requires reading the fault memory using the KTM diagnostics tool.
What to do if my KTM 125 Duke EU 2015 Motorcycle engine dies during the trip?
If the engine of your KTM Motorcycle dies during a trip, it might be due to a lack of fuel. In this case, refuel your motorcycle. Another potential cause is a blown fuse (1, 3, 4, or 8). If this is the case, replace the affected fuse.
Why KTM 125 Duke EU 2015 Motorcycle engine does not crank when the electric starter button is pressed?
If your KTM Motorcycle engine does not crank when you press the electric starter button, it could be due to several reasons. You may be experiencing an operating error, so go through the engine starting steps. The battery might be discharged, so you should recharge it. It's also possible that fuse 1, 3, 4, or 8 is blown, in which case you should replace the fuse. Finally, check the ground connection to ensure it is properly connected.
What does it mean if the engine diagnosis warning lamp (MIL) lights up red on KTM 125 Duke EU 2015?
If the engine diagnosis warning lamp (MIL) lights up red on your KTM Motorcycle, it indicates a fault in the fuel injection system. To resolve this, read out the fault memory using the KTM diagnostics tool.
Why is my KTM 125 Duke EU 2015 Motorcycle engine overheating?
If your KTM Motorcycle engine overheats, it could be due to several reasons. There might be too little coolant in the cooling system, so check for leaks and the coolant level. The radiator fins could be very dirty, so clean them. Foam formation in the cooling system can also cause overheating, so drain and refill/bleed the cooling system. A defective thermostat or a blown fuse 5 could also be the cause; check the thermostat and replace the fuse if necessary.
What to do if the ABS warning lamp lights up on my KTM 125 Duke EU 2015 Motorcycle?
If the ABS warning lamp lights up on your KTM Motorcycle (with ABS), it could be due to a blown ABS fuse. Replace the ABS fuses. It may also be due to a large difference in wheel speeds between the front and rear wheels. If this is the case, stop the vehicle, switch off the ignition, and start it again. Finally, it could indicate a malfunction in the ABS; in this case, read out the ABS fault memory using the KTM diagnostics tool.
Why does my KTM 125 Duke EU 2015 engine have too little power?
If your KTM Motorcycle engine has too little power, the air filter might be very dirty, so replace it. Another cause could be a very dirty fuel filter, so check the fuel pressure. A fault in the fuel injection system could also be the reason, so read out the fault memory using the KTM diagnostics tool.
Why is the combination instrument showing nothing on the display of my KTM Motorcycle?
If the combination instrument on your KTM Motorcycle shows nothing on the display, it may be due to a blown fuse 2 (without ABS) or fuse 8 (with ABS). Replace the fuse and set the clock.
Why are the headlight and parking light not functioning on my KTM Motorcycle?
If the headlight and parking light are not functioning on your KTM Motorcycle, it is likely that fuse 6 is blown. Replace the fuse.
Why are the turn signal, brake light, and horn not functional on my KTM Motorcycle?
If the turn signal, brake light, and horn are not functional on your KTM Motorcycle, it is likely that fuse 6 is blown. Replace the fuse.
General| Displacement | 124.7 cc |
|---|---|
| Bore x Stroke | 58 mm x 47.2 mm |
| Transmission | 6-speed |
| Fuel System | Electronic Fuel Injection |
| Rear Brake | 230 mm disc, single-piston caliper |
| ABS | Optional |
| Front Tire | 110/70-17 |
| Rear Tire | 150/60-17 |
| Seat Height | 810 mm |
| Starter | Electric starter |
| Engine Type | Single-cylinder, 4-stroke |
| Power | 11 kW (15 hp) @ 9, 500 rpm |
| Torque | 12 Nm @ 8, 000 rpm |
| Frame | Steel trellis |
| Front Suspension | WP upside-down fork |
| Rear Suspension | Monoshock |
| Front Brake | 300 mm disc |
| Fuel Tank Capacity | 11 liters |
| Cooling system | Liquid-cooled |
Emphasizes reading the manual for safety instructions and keeping warning labels on the vehicle.
Explains danger levels (Danger, Warning, Caution, Note) and their associated symbols.
Prohibits tampering with the noise control system and lists presumed acts of tampering.
Provides advice on safe operation, including avoiding impairment, ensuring ventilation, and handling hot components.
Recommends wearing protective clothing (helmet, boots, gloves, etc.) for increased safety.
Outlines rules for assembly, use of special tools, and checking parts after repair.
Stresses the importance of reading the manual before the first trip and keeping it accessible.
Highlights that proper service and tuning are crucial for optimal operation and preventing wear.
Shows a diagram illustrating the front-left view of the motorcycle with numbered components.
Describes the location and function of the clutch lever on the left handlebar.
Describes the location and function of the hand brake lever on the right handlebar.
Describes the location and function of the throttle grip on the right handlebar.
Explains the function of the light switch for low beam and high beam.
Explains the function of the emergency OFF switch to interrupt the ignition circuit.
Describes the location and operation of the electric starter button.
Explains the positions of the ignition lock and steering lock.
Details the instrument cluster: overview, activation, warnings, display modes, indicator lamps, and data menus.
Provides essential advice and warnings for the first use of the vehicle, including safety and handling.
Details the procedure and recommendations for engine running-in, including speed limits.
Warns about unstable handling due to improper loading and exceeding weight limits.
Lists essential checks (oil, brakes, tires, etc.) to ensure roadworthiness before every trip.
Details the safe procedure for starting the motorcycle's engine, including safety warnings.
Explains how to start moving from a standstill, including clutch and throttle control.
Provides guidance on shifting gears, riding defensively, and adapting speed to conditions.
Explains proper braking techniques, warnings about ABS, and stopping distances.
Details how to safely stop, park the motorcycle, secure it, and warnings about hot components.
Details the procedure for refueling the motorcycle with safety warnings about fuel hazards.
Lists recommended maintenance tasks and their intervals (1,000 km, 7,500 km, 15,000 km, and 4 years).
Explains how to check the drive chain tension and its importance for drivetrain.
Details the procedure for adjusting the drive chain tension for proper alignment.
Explains how to check wear on the chain and sprockets, recommending simultaneous replacement.
Explains the ABS system, its function, limitations, and safety aspects.
Details checking tires for damage, tread depth, age, and correct tread patterns.
Explains how to check and set the correct tire air pressure for solo and passenger loads.
Details how to check coolant antifreeze and level, with safety warnings about hot coolant.
Explains how to check coolant levels in the compensating tank and radiator.
Explains how to correctly check the engine oil level when the engine is at operating temperature.
Details the process for changing engine oil and filter, including cleaning the oil screen.
Provides instructions for adding engine oil, including recommended types and quantities.
Lists possible causes and actions for the engine not cranking.
Lists possible causes and actions for the engine failing to start.
Lists possible causes and actions for reduced engine power.
Lists possible causes and actions for the engine overheating.
Lists possible causes and actions for the engine stopping during a trip.
Lists possible causes and actions for a discharged battery.
Lists possible causes and actions for a blank instrument cluster display.
Provides detailed engine specifications for the 125 Duke and 200 Duke models.
To Next Page
