What to do if the engine turns but does not start on my KTM Motorcycle?
If the engine turns but does not start on your KTM Motorcycle, it could be due to a defect in the fuel injection system. Another possible reason is that the fuel quality is insufficient, so add suitable fuel.
What to do if the combination instrument shows nothing on the display on my KTM 1290 Super Duke R EU 2015 Motorcycle?
If the combination instrument on your KTM Motorcycle shows nothing on the display, several factors could be at play. It might be due to a blown Fuse 1, in which case you should change the fuses in the fuse box. Alternatively, the main fuse could be blown, requiring you to change the main fuse. A discharged battery could also be the culprit, so recharge the battery and check the open-circuit current. Lastly, a faulty ignition/steering lock could be the reason, so inspect the ignition/steering lock.
Why does my KTM Motorcycle engine die during the trip?
If your KTM Motorcycle engine dies during a trip, it could be due to a lack of fuel, so refuel your motorcycle. Another potential cause is a defect in the fuel injection system.
What does it mean if the ABS warning lamp lights up on my KTM 1290 Super Duke R EU 2015 Motorcycle?
If the ABS warning lamp lights up on your KTM Motorcycle, it could be due to a blown ABS fuse, so change the fuses in the fuse box. It could also be due to a large difference in wheel speeds of the front and rear wheels, in this case, stop the vehicle, switch off the ignition, and start it again. Another potential cause is a malfunction in the ABS.
What to do if the engine does not crank when the electric starter button is pressed on my KTM 1290 Super Duke R EU 2015 Motorcycle?
If the engine does not crank when you press the electric starter button on your KTM Motorcycle, first ensure that the emergency OFF switch is in the ON position. Another cause may be an operating error; make sure you carry out the start procedure correctly. A discharged battery could also be the issue, so recharge the battery and check the open-circuit current. Other potential causes include a faulty safety start system, a CAN bus communication error, a fault in the EFI control unit, or a fault in the MCU control unit.
Why is there a high oil consumption in my KTM 1290 Super Duke R EU 2015?
High oil consumption in your KTM Motorcycle can stem from a couple of issues. First, check if the engine oil level is too high. Also, the engine oil might be too thin (low viscosity), in that case change the engine oil and filter, and clean the oil screens.
Why is the battery discharged on my KTM Motorcycle?
If your KTM Motorcycle battery is discharged, it might be because the hazard warning flasher is switched on, so switch off the hazard warning flasher and recharge the battery. Another possible reason is that the battery is not being charged by the alternator, so check the charging voltage. Also, the ignition might not have been switched off while the vehicle was parked, so recharge the battery.
What does it mean if the engine warning lamp lights up/flashes on my KTM 1290 Super Duke R EU 2015 Motorcycle?
If the engine warning lamp lights up or flashes on your KTM Motorcycle, it could be due to a defect in the fuel injection system.
Why does the engine only turn if the clutch lever is drawn on my KTM 1290 Super Duke R EU 2015 Motorcycle?
If the engine only turns when the clutch lever is drawn on your KTM Motorcycle, it could be that the vehicle is in gear, so shift the transmission to idle. Another potential cause is a faulty safety start system.
General| Brand | KTM |
|---|---|
| Model | 1290 Super Duke R EU 2015 |
| Category | Motorcycle |
| Language | English |
To Next Page
