13 SERVICE WORK ON THE CHASSIS 101
Info
Chain wear is not always even, so you should check the setting at different chain
positions.
–
Tighten screw
.
Guideline
Screw, eccentric M16 70 Nm
(51.6 lbf ft)
Finishing work
– Remove the rear of the motorcycle from the lifting gear. ( p. 89)
13.16 Checking the chain, rear sprocket, engine sprocket, and chain guide
100132-10
– Check the rear sprocket and engine sprocket for wear.
» If the rear sprocket and engine sprocket are worn:
– Change the drivetrain kit.
Info
The engine sprocket, rear sprocket, and chain should always be replaced
together.
To Next Page
Loading...
Need help?
General
