21 STORAGE 167
– Lift the motorcycle with the front lifting gear. ( p. 90)
– Cover the vehicle with a tarp or similar cover that is permeable to air.
Info
Do not use non-porous materials since they prevent humidity from escaping,
thus causing corrosion.
Avoid running the engine for a short time only. Since the engine cannot warm
up properly, the water vapor produced during combustion condenses and causes
valves and the exhaust system to rust.
21.2 Preparing for use after storage
401059-01
– Take the motorcycle from the front lifting gear. ( p. 91)
– Remove the rear of the motorcycle from the lifting gear. ( p. 89)
– Install the battery. ( p. 128)
Info
If the battery was disconnected, the time and date must be set.
– Perform checks and maintenance measures when preparing for use. ( p. 66)
– Take a test ride.
To Next Page
Loading...
