EasyManua.ls Logo

KTM DUKE 125 User Manual

KTM DUKE 125
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
GD-MIP-0011-AD www.getdata.it sales@getdata.it
KTM DUKE 125 200 - 390:
GK-ECUJ5-0001/0006 INSTALLATION INSTRUCTIONS
WARNINGS
AVVERTENZE
PARTS LOCATION:
UBICAZIONE DELLE PARTI:
RACE USE ONLY POWER KIT !!!
Follow the instructions described in this manual to prevent vehicle damage or loss of performance
Don’t change or modify the parts supplied by Athena
Execute the installation when the engine is cold
During installation avoid that any part installed interferes with hot engine parts, driving parts or with the driver
No high-pressure washer on the GET ECU
IL KIT E’ DESTINATO SOLO ED ESCLUSIVAMENTE ALL’ USO AGONISTICO.
L’inosservanza delle norme presenti nel seguente manuale può compromettere il funzionamento del veicolo e/o perdita di potenza
Non modificare o sostituire il materiale fornito da Athena
Eseguire l’installazione a motore freddo
Evitare nel modo più assoluto che qualsiasi parte installata vada ad interferire con parti calde del motore, organi di guida o
con il pilota
Evitare getti d’acqua ad alta pressione (idropulitrici) sopra alla centralina GET
ECU
ENGINE
TEMP.
SENSOR
PICK-UP
INJECTOR
SIDE STAND
TPS
STEPPER
Question and Answer IconNeed help?

Do you have a question about the KTM DUKE 125 and is the answer not in the manual?

KTM DUKE 125 Specifications

General IconGeneral
Displacement124.7 cc
Transmission6-speed
Front SuspensionWP APEX 43
Rear SuspensionWP APEX Monoshock
Seat Height830 mm
Fuel Tank Capacity13.4 liters
Dry Weight139 kg
Bore x Stroke58 mm x 47.2 mm
Compression Ratio12.8:1
FrameSteel Trellis Frame, Powder Coated
Ground Clearance175 mm
HeadlightLED
Tail LightLED
Engine TypeSingle-cylinder, 4-stroke
Max Torque12 Nm @ 8, 000 rpm
Fuel SystemElectronic Fuel Injection
Rear BrakeDisc brake with single-piston floating calliper
InstrumentationDigital LCD display
Front BrakeDisc brake with four-piston radial fixed calliper
Wheelbase1, 366 mm

Summary

Pre-Installation Guidelines

Safety Warnings

Crucial safety instructions for installation and operation.

Parts Location Overview

Overview of the location of key parts on the motorcycle.

Harness Installation Procedures

ECU Side Installation

Connecting the harness to the ECU and routing cables.

Side Stand Cable Fitting

Installing the side stand sensor cable.

Pick-Up Sensor Cable Installation

Connecting the pick-up sensor cable to the engine.

TPS Cable Installation

Installing the throttle position sensor cable.

Coil Cable Installation

Connecting the ignition coil cable.

Injector Cable Installation

Fitting the fuel injector cable.

Stepper Motor Connection

Installing the stepper motor emulator.

Engine Map Switch Installation

Connecting the optional engine map switch.

Engine Temperature Sensor (Wire) Installation

Connecting the engine temp sensor via wire splice.

Slice Connector Usage Guide

Guide on using the supplied splice connector.

Engine Temperature Sensor (Connector) Installation

Connecting the engine temp sensor using its connector.

GET ECU Unit Installation

Mounting the GET ECU unit to the bike.

Final Calibration Procedure

Zero TPS Calibration Steps

Procedure to calibrate the throttle position sensor.

Related product manuals