3 WORK 6
Guideline
Screw, front wheel spindle M20x1.5 35 Nm
(25.8 lbf ft)
– Operate the hand brake lever several times until the brake linings are seated cor-
rectly against the brake disc.
– Remove the motorcycle from the lift stand. ( p. 5)
– Operate the front brake and compress the fork a few times firmly.
The fork legs straighten.
–
Tighten screws
.
Guideline
Screw, fork stub M8 15 Nm
(11.1 lbf ft)
Finishing work
– Remove the motorcycle from the lift stand. ( p. 5)
3.4 Installing the front fender
H01366-10
–
Position the front fender. Mount and tighten screws
.
Guideline
Screw, front fender M6 10 Nm (7.4 lbf ft)
The holding lugs on the fender engage in the start number plate.
3.5 Installing the start number plate
H01365-11
–
Position the start number plate. Mount and tighten screw
.
Guideline
Start number plate screw M6 4 Nm (3 lbf ft)
The holding lugs on the fender engage in the start number plate.
–
Position the brake line and clamp. Mount and tighten screw
.
3.6 Opening the filler cap
Danger
Fire hazard Fuel is highly flammable.
The fuel in the fuel tank expands when warm and can escape if overfilled.
– Do not refuel the vehicle in the vicinity of open flames or lit cigarettes.
– Switch off the engine for refueling.
– Make sure that no fuel is spilled; particularly not on hot parts of the vehicle.
– If any fuel is spilled, wipe it off immediately.
– Observe the specifications for refueling.
To Next Page
