SERVICE WORK ON THE CHASSIS 13
241
Guideline
Screw, fork protector M5x12 5 Nm (3.7 lbf ft)
Screw, fork protector M5x17 5 Nm (3.7 lbf ft)
– Repeat these steps on the opposite side.
13.26 Cleaning the dust boots of the fork legs
Preparatory work
– Raise motorcycle with rear lifting gear. ( p. 207)
– Remove the front fender. ( p. 238)
– Lift the motorcycle with the front lifting gear. ( p. 208)
F02053-10
Main work
(890 ADVENTURE R)
–
Push dust boots
1
of both fork legs downward.
Info
The dust boots remove dust and coarse dirt parti-
cles from the inside fork tubes. Over time, dirt can
accumulate behind the dust boots. If this dirt is not
removed, the oil seals behind can start to leak.
To Next Page
Loading...
