KTM F8201V5 - 3.3 Installing the front wheel

WORK 3
15
401943-10
(All XC‑F models)
– Remove the motorcycle from the lift stand.
– Remove the lift stand.
–
To park the motorcycle, press side stand
1
to the ground
with your foot and lean the motorcycle on it.
Info
When you are riding, the side stand must be folded
up and secured with the rubber strap.
3.3 Installing the front wheel
Warning
Danger of accidents Oil or grease on the brake discs reduces the braking effect.
– Always keep the brake discs free of oil and grease.
– Clean the brake discs with brake cleaner when necessary.
H00935-10
(SX‑F EU/US, XC-F US)
– Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
– Change front wheel bearing.
–
Clean and grease shaft seal rings
1
and contact sur-
faces
A
of the spacers.
Long-life grease ( p. 30)
–
Insert the spacers.
– Clean and grease the wheel spindle.
Long-life grease ( p. 30)
– Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
S01631-10
(XC‑F US FACTORY EDITION)
– Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
– Change front wheel bearing.
–
Clean and grease shaft seal rings
1
and contact sur-
faces
A
of the spacers.
Long-life grease ( p. 30)
– Insert the spacer and brake disc guard.
– Clean and grease the wheel spindle.
Long-life grease ( p. 30)
– Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.