Need help?Do you have a question about the KTM LC4 ADVENTURE R 640 2000 and is the answer not in the manual?
General| Brand | KTM |
|---|---|
| Model | LC4 ADVENTURE R 640 2000 |
| Category | Motorcycle |
| Language | English |
Key information and instructions for safe and proper operation of the motorcycle.
Welcome and overview of the owner's handbook contents and purpose.
Locating important identification numbers for the motorcycle.
Identification and function of the motorcycle's control panel and instruments.
Description and adjustment of clutch lever play and hand decompression lever usage.
Operation and correct play of the choke lever for cold starts.
Description and warning for the proper functioning of the hand brake lever.
Explanation of dashboard indicator lamps and ignition lock switch positions.
Functionality of the tachometer and overview of the tripmaster system.
Procedure for correcting total kilometers and parametrizing the tripmaster.
Operation of combination switch, starter switches, fuel cap, and fuel taps.
Operation of shift lever, kickstarter, and foot brake pedal.
Adjusting the front fork's compression and rebound damping.
Adjusting rear shock absorber damping, helmet lock, and baggage carrier.
Essential checklist for safe operation before each ride.
Guidance for first-time operation and the engine break-in period.
Step-by-step procedures for starting the engine cold, warm, or hot.
Troubleshooting steps for a flooded engine condition.
Proper technique and safety warnings for kickstarting and moving off.
Guidance on gear shifting, throttle control, and effective braking techniques.
Procedures for safely stopping the engine and parking the motorcycle.
Instructions for easily and safely placing the motorcycle on its center stand.
Location of the tool kit and procedure for removing/installing the seat.
Bleeding front fork, checking steering head bearing play, and adjustment.
Procedure to adjust rear shock absorber spring preload based on rider weight.
Greasing the shock absorber linkage bearings for proper function.
Procedure and specifications for checking and adjusting drive chain tension.
General tips for chain maintenance and checking for chain wear.
Details on brake calipers, pads, fluid, and general disc brake system.
Adjusting front brake lever travel and checking front brake fluid level.
How to inspect the thickness of the front brake pads.
Adjusting foot brake pedal position and checking rear brake fluid level.
How to inspect the thickness of the rear brake pads.
Procedure for safely removing and reinstalling the front wheel.
Procedure for safely removing and reinstalling the rear wheel.
Checking rear hub rubbers and tire condition/pressure.
Procedure for checking spoke tension and when to seek dealer service.
Battery location, maintenance, and procedures for charging.
Location and replacement of main and individual fuses.
Procedure for removing headlight mask and replacing headlight bulb.
Procedure for replacing tachometer and indicator lamp bulbs.
Explanation of the cooling system, its components, and operation.
Checking cooling liquid level and adjusting engine idle speed.
Adjusting throttle cable and draining the carburetor float chamber.
Adjusting choke, clutch, decompression cables, and draining carburetor.
Specifications for engine oil type, viscosity, and quality requirements.
Step-by-step procedure for checking the engine oil level.
Diagram and explanation of the engine oil circulation path.
Procedure for changing engine oil, fine screen filter, and oil filter.
Troubleshooting engine overheating, oil consumption, and electrical system failures.
Troubleshooting blank tripmaster display, speed, and time entry issues.
Recommended procedures for cleaning the motorcycle's exterior surfaces.
Precautions for protecting the motorcycle from winter conditions like salt spray.
Instructions for preparing the motorcycle for storage and re-initiating after storage.
Specifications for correct tightening torques of engine fasteners.
Engine component clearances and wear limits for proper assembly and function.
Factory standard adjustment settings for shock absorber and fork.
Specifications for correct tightening torques of chassis fasteners.
Procedure for reporting vehicle safety defects to NHTSA.
Noise emission warranty, tampering warnings, and related statements.
To Next Page