Kubota AP-SSG2524 - Control Harness With Deutsch 2 Pin Plug

Section 4: Options
Table of Contents
11/13/19
AP-SSG2524 Stump Grinder 328-215MK
21
Control Harness With Deutsch 2 Pin Plug
Refer to Figure 4-2:
370-434A Kubota CTL Skid Steer Control Harness
This harness is used with skid steers equipped with a
Deutsch 2 pin coupler but not the Deutsh HD30 14 pin
coupler. It consist of the following:
Refer to Figure 4-3:
• Power cord (#1): Attach Deutsch 2 pin plug (#1) to
Kubota’s CTL male plug (#7) located behind the
driver’s seat.
Refer to Figure 4-4:
• 10 amp Fuse (#8): Fuse (#8) is supplied by customer.
Install 10 amp fuse (#8) in Kubota’s fuse box slot #17
labeled “Electrical Outlet-2”.
Refer to Figure 4-2:
• Power cord (#1): Attaches to Deutsch 2 pin connector
and to control box (#2).
• Control box (#2): Mounts in a convenient location for
the operator to access from the operator’s seat.
• Wire harness (#3): Attaches to control box (#2) and
runs from the control box to the loader arm.
• Wiring harness (#4): Attaches to wire harness (#3) at
the loader arm and at the solenoids on the Stump
Grinder.
• Cable ties (#5): For securing wire harnesses
(#1, #3, & #4) to the skid steer and Stump Grinder.
Toggle Switch Control Harness For Kubota CTL Skid Steers
Figure 4-2
37145
Kubota Power Connection (Located Behind Drive Seat)
Figure 4-3
Installation of 10 amp Fuse
Figure 4-4
37389
1
7
37390
8
1 823-439C HRN DTP04-2P 14GA 2WPS /5’ (5 ft. long.) 1
2 823-377C CONTROL BOX 2 PRIORITY 1
3 823-385C HARNESS EXTENSION (11' - 0" long.) 1
4 823-405C HARNESS SOLENOID 2 PRIORITY (8' - 11" long.) 1
5 800-112C CABLE TIE .19X7.25 1.75D 50LB 16
Kit No. 370-434A Control Harness Kubota Skid Steer
Item Part No. Part Description Qty