Kubota DMC 8536R - User Manual

Questions and Answers

J
James RosalesAug 5, 2025
Why is there uneven stubble with Kubota Farm Equipment?
- H
  Heather LynchAug 5, 2025
  If you notice uneven stubble when using your Kubota Farm Equipment, several factors could be at play. It might be caused by driving too slowly, so try increasing your speed. Alternatively, the tractor RPM on the P.T.O. could be too low, in which case you should check the RPM. Also, inspect the blades; if they are blunt or missing, turn or replace them. Finally, the machine may not be correctly balanced, so adjust the springs.
H
Hannah DeleonAug 9, 2025
Why is the conditioning too weak on my Kubota Farm Equipment?
- C
  calebrobertsAug 9, 2025
  If the conditioning is too weak on your Kubota Farm Equipment, there are several things to check. First, adjust the roller pressure if it's too low. If your driving speed is too high, reduce it. Also, make sure to check the V-belts at the roller to ensure they are sufficiently tightened. Finally, if the roller V-belts are worn, replace them.
E
emily13Aug 14, 2025
Why are there stripes in the stubble with Kubota DMC 8536R Farm Equipment?
- C
  Chelsey BrooksAug 14, 2025
  If you notice stripes in the stubble when using your Kubota Farm Equipment, it could be because the cutterbar is not correctly angled for the crop in question, so adjust the angle of the cutterbar. Another possible cause is that the cutterbar is fitted with high skids, so remove the high skids.
B
Brian RobersonAug 17, 2025
What to do if there are uneven swathes with Kubota DMC 8536R?
- M
  Mary SaundersAug 18, 2025
  If your Kubota Farm Equipment is producing uneven swathes, the rotor's RPM may be too low, so adjust the rotation of the rollers to 1200 RPM. Additionally, the deflector plate might be incorrectly set, so adjust the deflector plates.
S
Scott MullenAug 22, 2025
Why does the cutterbar get abnormally warm on Kubota DMC 8536R Farm Equipment?
- B
  Brandon Morton MDAug 22, 2025
  If the cutterbar on your Kubota Farm Equipment gets abnormally warm, it could be caused by too much oil in the cutterbar, so inspect the oil level. Alternatively, the wrong oil type could be the issue, so change to the correct oil type.
R
Ricky HerreraAug 27, 2025
What to do if the cutting unit receives violent shocks during road transport with Kubota Farm Equipment?
- S
  Sergio Serrano MDAug 27, 2025
  If the cutting unit of your Kubota Farm Equipment receives violent shocks during road transport, the machine's accumulator may have too little pressure or is defective, so check or replace the accumulator. Also, the safety valve may be closed, ensure that the safety valve is open.
C
Cynthia RojasAug 31, 2025
Why is Kubota DMC 8536R sloping to the rear during mowing?
- C
  Caleb DeleonAug 31, 2025
  If your Kubota Farm Equipment is sloping to the rear during mowing, it indicates there is too much downward pressure on the cutterbar. Adjust the springs to resolve this issue.