Kubota G2160 - Torque Sensor 3 P Connector

5-S18
G2160, WSM
STEERING
(3) Torque Sensor 3P Connector
Checking Torque Sensor 3P Connector
IMPORTANT■
• While disassembling, handle the power steering assembly,
controller and wire harness with enough care. To
disconnect the steering wheel, be sure to use the steering
wheel puller (1) and puller adaptor (2), never any hammer.
Excessive load or impact on the parts may result in trouble.
• To disconnect the connector, press the connector's lock
and hold the connector itself. Never pull the cable.
1. Check the torque sensor 3P connector (3) and related parts for
the following defects.
- Terminal off position
- Terminal deformed or crushed
- Female terminal too open
- Entry of foreign matters, water, etc.
- Rubber sealing missing
- Broken wire or sheath
2. If any of the above problems is found, repair the trouble spot or
replace the power steering assembly with new one. If there is no
problem, go to the following check point.
W1013417
(1) Steering Wheel Puller
(2) Puller Adaptor
(3) Torque Sensor 3P Connector
KiSC issued 11, 2006 A