Kubota J106-STD - Connecting the Load (aus Model)

CONNECTING THE LOAD18
ENGLISH
A For single phase power source
i ) J310-STD, J315-STD, J320-STD
50Hz 380V single phase Use (U)-(V), (V)-(W), (W)-(U)
ii) J313-STD, J318-STD, J324-STD
60Hz 220V single phase Use (U)-(V), (V)-(W), (W)-(U)
[Single phase]
BConnecting the Load (AUS Model)
To avoid personal injury:
A Connect or disconnect the load to
the AC receptacle only when the
engine is stopped.
1. Turn OFF the circuit breakers on the control panel.
2. Connect the load to the A.C. receptacles.
[Receptacles use]
(1) Electric drill
(2) Motor pump
(3) Air conditioner
(1) Circuit breaker
(1) Single phase
(2) 3 phase
[ A list of receptacles ]
Single Phase 3 Phase
Model 56S0315 56S0310 56S0520 56S0532
J106-
AUS
2000
J108-
AUS
3000
J112-
J116-
AUS
4000
J310-
AUS
0310
J315-
J320-
AUS
3001