Kubota L3901 User Manual

2. If
the hoses and hose clamps are found worn or
damaged, replace or repair them at once.
(1) Hose (2) Hose clamps
3. Checking the radiator hose and
clamp
WARNING
To avoid personal injury or death:
•
Be sure to stop the engine and remove the
starter key before changing the radiator hose
and hose clamps.
Check the radiator hose and clamp every year.
1. Check to see if radiator hoses are properly fixed.
2. If hose
clamps are loose or water leaks, tighten the
bands securely.
3. Replace the hoses and tighten the hose clamps
securely, if radiator hoses are swollen, hardened, or
cracked.
(1) Radiator hoses (2) Clamp bands
4. Checking the power steering line
[Manual transmission type only]
WARNING
To avoid personal injury or death:
•
Be sure to stop the engine and remove the
starter key before changing the power-steering-
line.
1. Check to see that all lines and hose clamps are
tight and not damaged.
2.
If hoses and hose clamps are found worn or
damaged, replace or repair them at once.
(1) Power steering pressure ho-
ses
5. Checking the oil cooler line [HST
type only]
WARNING
T
o avoid personal injury or death:
•
Be sure to stop the engine and remove the
starter key before changing the oil-cooler-line.
PERIODIC SERVICE SERVICE EVERY 1 YEAR
120
L3301,L3901

Kubota L3901 Specifications

General

Engine Type	Diesel
Engine Horsepower	37.5 HP
3-Point Hitch	Category I
Weight	2, 623 lbs (Gear Drive), 2, 778 lbs (Hydrostatic)
Displacement	111.4 cu in
Cylinders	3
Displacement (cu in)	111.4
Hydraulic System Type	Open center
Width	55.1 inches
Transmission Type	Gear or HST
Fuel Capacity	11.1 gal
Gears	8 forward, 4 reverse (Gear)
Number of Gears	8 forward, 4 reverse
Fuel Tank Capacity	11.1 gal
Lift Capacity at 24"	1433 lbs
Height	91.7 inches
Tire Size (Front)	7-16
Tire Size (Rear)	11.2-24
Engine Model	D1803