Kubota LA434 User Manual

20 OPERATING THE LOADER
DETACHING AHACHMENTS
1. Detaching attachments is done in the reverse of
attaching attachments. The procedure is below.
2. Lower the attachment to ground level with the
attachment slightly inthe rolledback position.Stop the
engine and set the parking brake.
3. Pull the quick attach coupler handles to the unlatched
position to release the latching pins.
4. While sitting in the tractor operator's seat, start the
engine and slowly move the loader control lever to the
"DUMP" position until the attachment is pushed away
slightlyfrom the quick attach coupler.
5. Lowerthe loader boom so that the quickattach coupler
mounting plate clears the attachment saddle.
6. Back away from the attachment slowly.
7. If an attachment is not going to be attached to the
quick attach coupler immediately,push the handles of
the quick attach coupler to the locked position to
prevent damage to the handle assembly.
DISMOUNTING THE LOADER
A WARNING
To avoid machine damage or serious injury:
• Remove ioader from tractor oniy when an
approved ioader buclcet is attached.
Follow instructions provided in "REMOVING
LOADER" section in this operator's manual.
THE
AnACHMENTS
•Bucket
4FAAAAMAP002B
-SQUARE 50" (RIGID)
WIDTH
1 270 mm
STRUCK CAPACITY
0.154 cu.m.
-SQUARE 54" (QUICK)
WIDTH
1 370 mm
STRUCK CAPACITY
0.19 cu.m.
-SQUARE 60" LM (RIGID)
WIDTH
1 525 mm
STRUCK CAPACITY
0.23 cu.m.
-SQUARE 60" LM (QUICK)
WIDTH
1 525 mm
STRUCK CAPACITY
0.23 cu.m.

Kubota LA434 Specifications

General

Brand	Kubota
Model	LA434
Category	Front End Loaders
Language	English