Kubota LA434 User Manual

24 MAINTENANCE
DAILY CHECKS
1. Check all hardware dally before operation.
Tighten hardware to torque values as specified in the
"Installation Instructions"
and "Tightening Torque
Chart".
2. With the engine off and the bucket on the ground,
inspect all
hoses for cuts or wear. Check for signs of
leaks and make sure all fittings are tight.
A WARNING
To avoid serious personal injury:
• Escaping hydraulic fluid under pressure can
have sufficient force to penetrate skin, causing
serious personal injury. Before disconnecting
lines, be sure to relieve all pressure.
Before applying pressure to the system, be
sure all connections are tight and that lines,
tubes, and hoses are not damaged. Fluid
escaping from a very small hole can be almost
invisible. Use a piece of cardboard or wood,
rather than your hands, to search for
suspected leaks.
1AIABACAP041A
(1) Hydraulic line
(2)
Cardboard
(3) Magnifying glass
If injured by escaping fluid, see a doctor at
once. Serious infection or allergic reaction will
develop if proper medical treatment is not
administered immediately.
When removing the engine side covers, be
careful not to touch hot loader cylinders.
Allow all surfaces to cool before performing
maintenance.
Before servicing the loader or the tractor, be
sure to place the loader boom in contact with
the ground. If the loader boom must be raised
during service or maintenance, support the
boom as shown in the figure.
1AIABDIAP007A

Kubota LA434 Specifications

General

Brand	Kubota
Model	LA434
Category	Front End Loaders
Language	English