OPERATING THE LOADER18
FRONT REMOTE HYDRAULIC CONTROL
SYSTEM (if equipped)
This system can be used for a front mounted hydraulic
implement, as it provides hydraulic oil to the front outlet
directly.
BInstall the Coupler
1. Remove the cap from the front hydraulic outlet.
2. Install the hydraulic quick coupler as required.
BControl Switch
1. Front hydraulic valve main switch
Push the front hydraulic valve main switch (1) to
engage the front hydraulic valve.
A light on the switch will illuminate to indicate that the
front hydraulic valve is on, and to enable the activation
switch (2).
2. Activation switch
A When pressing the "A" button, hydraulic oil will
come out of Port A and return through Port B as
long as the switch is pressed.
A When pressing the "B" button hydraulic oil will
come out of Port B and return through Port A as
long as the switch is pressed.
3. Push the front hydraulic valve main switch again to
disengage the front hydraulic valve, and the light of the
front hydraulic valve main switch will turn off.
A While a front mounted hydraulic attachment is used,
make sure the hydraulic hose is routed out of contact
with the left and right bucket links. (Keep the hose from
running over within the circled zone in the figure
below.)
(1) Front hydraulic outlet
(2) Hydraulic quick coupler (Not included in this kit)
(1) Front hydraulic valve main switch
(2) Activation switch
(C) Front hydraulic valve main switch "OFF"
(D) Front hydraulic valve main switch "ON"
To Next Page
Loading...
Need help?
General
