Kubota M7-172 User Manual

7. Check
on the LCD monitor that the shuttle shift
selected in step 4 (forward or reverse) is
automatically selected.
8. If any trouble occurs, consult your local KUBOTA
Dealer for this service.
1.9 Testing operator presence control
(OPC) system of shuttle lever (Premium
KVT model)
(1) Shuttle lever
(2)
Clutch pedal
(3) Liquid crystal display
1. Follow the instructions about parking the tractor.
(See P
ARKING THE TRACTOR on page 15.)
2. Sit on the operator's seat.
3. After starting the engine, release the clutch pedal.
4. Check on the LCD monitor that when you are
standing, the gearshift will remain in “NEUTRAL”
even if you try to shift gears with the shuttle lever to
the “FORWARD” or “REVERSE” position.
5. If any trouble occurs, consult your local KUBOTA
Dealer for this service.
2. Checking wheel bolt torque
WARNING
T
o avoid personal injury or death:
• Never operate the tractor with a loose rim,
wheel or axle.
• Any time bolts and nuts are loosened, retighten
to the specified torque.
• Check all bolts and nuts frequently and keep
them tight.
Check wheel bolts and nuts regularly, especially when
new
. If they are loose, tighten them as follows.
Flange type
(1) 540 N
⋅ m / 55.1 kgf ⋅ m / 398 ft ⋅ lbs
(2) 670 N ⋅ m / 68.3 kgf ⋅ m / 494 ft ⋅ lbs
Bar type axle (10 bolts fix type)
(1) 540 N
⋅ m / 55.1 kgf ⋅ m / 398 ft ⋅ lbs
(2) 670 N ⋅ m / 68.3 kgf ⋅ m / 494 ft ⋅ lbs
(3) 543 N ⋅ m / 55.4 kgf ⋅ m / 400 ft ⋅ lbs
Bar type axle (8 bolts fix type)
(1) 540 N
⋅ m / 55.1 kgf ⋅ m / 398 ft ⋅ lbs
(2) 670 N ⋅ m / 68.3 kgf ⋅ m / 494 ft ⋅ lbs
(3) 350 N ⋅ m / 35.7 kgf ⋅ m / 258 ft ⋅ lbs
3. Checking tie-rod dust cover
Check to see that dust covers are not damaged.
If
dust covers are damaged, consult your local
KUBOTA Dealer for this service.
EVERY 50 HOURS PERIODIC SERVICE
M7-132,M7-152,M7-172
249

Kubota M7-172 Specifications

General

Brand	Kubota
Model	M7-172
Category	Tractor
Language	English