Kubota R430 - Page 105

Error
code
number
Problem or Failure
Machine condition
Provisional measure and
Correction
Engine performance
Machine performance
Acceleration
limited
Engine out-
put limited
Engine stop-
ped
E:9103
Intake air tempera-
ture sensor system
- - -
The engine may get started
and the machine may move.
But do not try any jobs.
Immediately contact your local
dealer
.
E:9104
Coolant temperature
system
◎ ◎ -
The meter does not show wa-
ter temperature. Press the dis-
play-selector-switch, and the
normal display is switched
back. The other functions of
machine are operative, but an
overheat and other problems
cannot be detected.
Immediately contact your local
dealer
.
E:9106 Injector system ◎ ◎ ○
The engine may be stopped,
and engine rpm and output is
limited.
Immediately contact your local
dealer
.
E:9107
Intake air pressure
sensor system
- ○ -
The engine rpm may be limit-
ed. The machine may move.
But do not try any jobs.
Immediately contact your local
dealer
.
E:9108
Battery voltage sys-
tem
◎ ◎ ○
The engine may be stopped.
The engine rpm and output is
limited.
Immediately contact your local
dealer
.
E:9109
Sensor voltage sys-
tem
◎ ◎ ○
The engine may be stopped.
The engine rpm and output is
limited.
Immediately contact your local
dealer
.
E:9110 Main relay system - - -
The engine may get started
and the machine may move.
But do not try any jobs.
Immediately contact your local
dealer
.
E:9112
Atmospheric pres-
sure sensor system
- ○ -
The engine output may be lim-
ited. The other functions of
machine are still operative.
Immediately contact your local
dealer
.
E:9113 EGR valve system - ◎ -
The engine output is limited.
The other functions of machine
are still operative.
Immediately contact your local
dealer
.
E:9114
Coolant temperature
warning
- - - ---
1. For correction, see the
Coolant temperature
gauge on page 36.
2. If “E:9114” still appears,
immediately contact your
local dealer.
E:9115
Engine overheat
warning
- ◎ -
The engine automatically re-
duces rpm's to avoid an over-
heat.
1. For
correction, see the
Coolant temperature
gauge on page 36.
2. If “E:9115” still appears,
immediately contact your
local dealer.
E:9117 Air heater system - - -
The engine may get started
and the machine may move.
But do not try any jobs.
Immediately contact your local
dealer
.
E:9118
Engine oil pressure
system
- - -
The engine-lubricating-system-
oil-pressure is too low
.
1. Stop
the engine and
check the engine-oil-level.
2. If “E:9118” still appears,
immediately contact your
local dealer.
E:9119
Charging system fail-
ure
- - -
Charging system is in trouble.
The battery is not charging.
1. Stop
the engine and
check the V-belt.
2. If “E:9119” still appears,
immediately contact your
local dealer.
(Continued)
TROUBLESHOOTING
R430
101