Maintenance
64
Maintenance terms
Listed in this table are short explanations of the most important
maintenance terms.
Maintenance
intervals
Task Explanation
Greasing Apply grease to the slide surfaces using a brush.
Lubrication One or two presses of the grease gun, unless specified otherwise.
Oiling
Unless specified otherwise, use only plant-based oils, such as rapeseed oils.
The use of used oil will endanger your health and is also strictly prohibited.
Replacement
Replace the appropriate part in accordance with the instruction in the
Maintenance chapter.
Inspection
Check the tyre pressures, adjustment dimensions and seal tightness as
required, and replace any worn parts or seals.
Observe the maintenance
intervals
The specifications relate to an average usage of the machine. If subjected to
heavier duty (e.g. by contracting companies), select the maintenance
intervals to be shorter. Also, for extreme working conditions (for example
heavy dust creation), shorter maintenance intervals are possible.
After 5 hours of operation
Daily
After 20 hours of operation
After 50 hours of operation
After 250 hours of operation
Once per season
After heavy use
As required
In case of wear
Lubrication
Greasing
Inspection
Replacement
Cleaning
Page
General
All bolts
• • • 65
Visual inspection •••
Bearing
• • 67
Hose connections ••
Air pressure
• • • • 69
Lighting equipment •••
Hydraulics
Hydraulic hoses every 6 years • 70
Hydraulic cylinders
• •
Hydraulic couplings ••
PTO shafts
Wide-angle joint •• • 67
PTO shaft guard
• • • 68
Profile section tube ••68
Gear box
Rotor gear ••69
To Next Page
Loading...
Need help?
General
