Additional equipment
71
Additional equipm ent
Optional
accessories
You can purchase additional equipment through your dealer.
Tine saver [+]
For a good swath deposit, both tine legs must run parallel to one
another. This must also be ensured after fitting the tine saver.
Proceed as follows:
Fit one tine saver on each tine.
Check the direction of rotation of the rotor. The nuts must be
attached against the rotor direction.
Check the tine position. The tine legs must be parallel.
If necessary, loosen the screwed connection until both tine legs run
parallel.
Support wheel [+]
To ensure the machine offers even better contour guidance during
operation, the manufacturer can also supply an optional support
wheel. The support wheel can be fitted on the right or on the left.
When using the optional support wheel, ensure that a lift of at least
10 mm is guaranteed for the drawbar cylinder.
Lift link drawbar [+]
As a special accessory, there is a rotatable lift link drawbar for “cate-
gory II”.
To Next Page
Loading...
Need help?
General
