Kubota WSM B2650 User Manual

TRANSMISSION
B2050, B2350, B2650, B3150, WSM
3-S15
[2] PREPARATION
(1) Draining Lubricants and Coolant
Draining Engine Oil
CAUTION
• Before changing oil, be sure to stop the engine.
1. Start and warm up the engine for approx. 5 minutes.
2. Place an oil pan underneath the engine.
3. To drain the used oil, remove the drain plug (1) at the bottom of
the engine and drain the oil completely.
4. Screw in the drain plug (1).
5. Fill new oil up to upper line on the dipstick (2).
IMPORTANT
• When using an oil of different manufacture or viscosity
from the previous one, remove all of the old oil.
• Never mix two different types of oil.
• Use the proper SAE Engine Oil according to ambient
temperatures.
Refer to G-8.
9Y1210982ENS0023US0
Engine oil capacity
B2050, B2350
3.1 L
3.3 U.S.qts
2.8 Imp.qts
B2650, B3150
4.0 L
4.2 U.S.qts
3.5 Imp.qts
(1) Drain Plug
(2) Dipstick
(3) Oil Inlet Plug
(A) Oil level is acceptable within this
range.
KiSC issued 03, 2014 A

Kubota WSM B2650 Specifications

General

Engine Type	Diesel
PTO Power	19.5 HP
Transmission Type	Hydrostatic
Type	Compact Utility Tractor
Fuel	Diesel
Number of Cylinders	3
Brakes	Wet disc
Power Steering	Yes
Mid PTO	Optional
Hydraulic System Type	Open center
3-Point Hitch	Category I
Engine Power	26 HP
Wheelbase	61.4 in
Rated RPM	2700
Number of Forward/Reverse Gears	3-range
Tire Size (Front)	25x8.50-14
Tire Size (Rear)	13.6-16
Displacement	77.0 cu in