Need help?Do you have a question about the Kubota Z122E and is the answer not in the manual?
General| Transmission | Hydrostatic |
|---|---|
| Drive System | 2WD |
| Cylinders | 2 |
| Transmission Type | Hydrostatic |
| Deck Type | Stamped |
| Wheel Size - Front | 11 x 4-5 |
| Wheel Size - Rear | 18 x 7.5-8 |
| Engine Type | Gasoline |
| Cutting Width | 42 in |
| Cutting Height Range | 1.5 - 4.5 inches |
| Deck Size | 42 in |
| Fuel Tank Capacity | 3.5 gal |
| Turning Radius | Zero |
| Speed Range | 0-7 mph |
| Warranty | 3 years / 300 hours |
Key steps and safety checks before starting machine operation.
Guidelines for starting, working, and general machine operation, including safety.
Critical safety procedures and precautions for operating the machine on inclines and slopes.
Understanding danger, warning, and caution labels for safe machine use.
Step-by-step instructions and safety precautions for starting the engine.
Checks during operation, cold weather starting, and jump-starting procedures.
Procedures for warming up the engine and safely stopping the machine.
Precautions and procedures for the initial operation and break-in of a new machine.
Steps to prepare and start the machine, including seat and belt adjustments.
Instructions on how to use the motion control levers for steering and speed.
Procedures for safely stopping the machine and parking it securely.
Tips for achieving optimal mowing results and lawn appearance.
Instructions on how to set and adjust the mower deck's cutting height.
Procedures for adjusting the mower deck side-to-side and front-to-rear.
Schedule of recommended service tasks based on operating hours and time.
Essential checks to perform daily to ensure machine condition and prevent issues.
Recommended lubricants, fuel types, and high altitude considerations.
Specific maintenance tasks to be performed every 25 hours of operation.
Specific maintenance tasks to be performed every 50 hours of operation.
Specific maintenance tasks to be performed every 100 hours of operation.
Procedures for adjusting the motion control levers, including HST neutral.
Procedures for adjusting the mower deck side-to-side and front-to-rear.
Reference tables for general and specific tightening torque values.
Steps to prepare the machine for storage, including cleaning and fluid checks.
Procedures for preparing the machine after a period of storage.
Common engine problems, their causes, and corrective measures.
Troubleshooting common issues related to the battery and machine operation.
Common mower problems, their causes, and corrective measures for cut quality.
To Next Page
