How to reduce power needed when using KUHN Tiller in dry conditions?
To reduce the power needed when working in dry conditions with your KUHN Tiller, adjust the machine to a higher setting using the roller, wheels, or skids, ensuring the depth is no deeper than necessary. Replace the entire set of blades to maintain rotor balance. Also, reduce the rotor speed.
How to decrease power consumption of KUHN Tiller in humid conditions?
To reduce the power needed when working in humid conditions with your KUHN Tiller, adjust the machine to a higher setting using the roller or wheels, ensuring the depth is no deeper than necessary. Open the hoods to allow ground to flow more freely and raise the hood flaps. Additionally, reduce the rotor speed.
Why is my KUHN EL 142 Tiller drive noisy during work?
If the drive of your KUHN Tiller is noisy during work, it could be due to the machine being tilted. Lengthen or shorten the top link to set the machine horizontally during work, ensuring the tractor PTO stud and machine input shaft are parallel. Also, tighten the tractor's anti-sway stabilizers to better stabilize the machine.
What to do if KUHN EL 142 Tiller produces tilth too coarse?
If your KUHN Tiller is producing a tilth that is too coarse, increase the rotor speed. Close the hoods, and lower the hood flaps if needed. Reduce your forward speed.
Why is KUHN EL 142 Tiller throwing soil too far to the rear?
If your KUHN Tiller is throwing soil too far to the rear, alter the positions of the hoods and their flaps.
How to prevent vegetable residue build up with KUHN Tiller and seed drill?
If you experience vegetable residue build up on seed drill coulters when using a KUHN EL 142 / seed drill combination, it may be due to poor shredding and distribution of vegetable residue. Consider operating an independent shredder first or use a seed drill specially equipped for seeding in vegetable residue.
Why is my KUHN Tiller causing ridging across the pass width?
If you notice ridging across the pass width when using your KUHN Tiller, it could be because the machine jerks and jolts during work. Make necessary adjustments to forward speed by reducing it slightly, rotor speed, and working depth by slightly increasing it. Also, consider opening or closing the hoods and their flaps.
How to fix noisy drive when lifting KUHN EL 142?
If the drive of your KUHN Tiller is noisy when lifting the machine, it might be due to the top link of the 3-point hitch being badly positioned or adjusted. Position the top link parallel to the lower lift arms. It could also be due to excessive lifting height. Reduce the lifting height, and if the problem persists, disengage the PTO shaft when lifting the machine.
Why is seedbed ground over-aerated by KUHN EL 142?
If the seedbed ground is over-aerated when using your KUHN Tiller, it could be due to not enough pressure on the roller. Lengthen the top link. It may also be because the soil is too fine, due to the rotor over-working the soil. Reduce rotor speed.
To Next Page
General
