Why does my KUHN Tiller require excessive power in dry conditions?
Excessive power requirement in dry working conditions can occur if the working depth is too deep. To resolve this, set and control the working depth. Another possible cause is incorrect hood positioning, which can be fixed by adjusting the hood position.
Why does my KUHN EL32 Tiller require excessive power in wet conditions?
Excessive power requirement in very wet working conditions can be due to a working depth that is too deep. To solve this, set and control the working depth. Another cause can be excessively worn tools; replace the whole set of tools to ensure rotor balance.
Why is my KUHN EL32's drive noisy during operation?
A noisy drive during work with your KUHN Tiller can occur if the machine is tilted to the front or rear. Correct this by lengthening or shortening the top link to set the machine horizontally during work. Another cause is insufficient machine side to side stabilization; adjust the stabilizers of the lower links to prevent machine side to side or up and down movements.
How to fix coarse soil tilth with my KUHN EL32 Tiller?
If your KUHN Tiller is producing a tilth that is too coarse, it could be due to excessive ground speed. Reduce ground speed to correct this. Another possible reason is incorrect hood positioning, which can be resolved by adjusting the hood position.
What to do if my KUHN Tiller projects ground to the rear?
If your KUHN Tiller is projecting ground to the rear, it is likely due to incorrect hood positioning. Adjust the hood position to resolve this issue.
Why is the drive noisy when lifting my KUHN Tiller?
A noisy drive when lifting your KUHN Tiller can be caused by a badly positioned or adjusted top link of the 3-point hitch. To fix this, position the top link parallel to the lower links. It can also be caused by an excessive lifting height; limit the lift linkage stroke.
Why does my KUHN EL32 cause an irregular mix of plant residues?
An irregular mix of plant residues with your KUHN Tiller may occur if the working depth is insufficient. Set and control the working depth to ensure proper mixing.
What causes ridging across the path width with my KUHN EL32 Tiller?
Ridging across the path width with your KUHN Tiller can be caused by tractor-machine unit swaying. Modify one or several adjustment parameters: reduce ground speed, increase working depth, or adjust hood position.
Provides general safety precautions for operating the machine.
Identifies the placement and meaning of safety decals on the machine.
Details safety equipment and recommendations for road use.
Explains the procedures for attaching and detaching the machine.
Details guidelines and regulations for transporting the machine.
Explains how to adjust working depth and other parameters.
Provides essential guidelines for operating the machine safely.
Details lubrication procedures for the PTO shaft and gearboxes.
Guides on replacing worn or damaged blades with genuine parts.
To Next Page
General
