Why does my KUHN EL22 have excessive power requirement in dry conditions?
Excessive power requirement in dry conditions can occur if the working depth is too deep. To resolve this, set and control the working depth. Another possible cause is incorrect hood positioning, which can be corrected by adjusting the hood position.
Why does my KUHN EL22 have excessive power requirement in wet conditions?
Excessive power requirement in very wet conditions can occur if the working depth is too deep. To resolve this, set and control the working depth. Also, excessively worn tools can cause this issue; replace the whole set of tools to ensure rotor balance.
What to do if my KUHN Tiller's tilth is too coarse?
If the tilth is too coarse, it could be due to excessive ground speed. Try reducing the ground speed. Incorrect hood positioning can also cause this; adjust the hood position to correct it.
What to do if my KUHN Tiller has a noisy drive during work?
A noisy drive during work may be due to the machine being tilted to the front or rear. Lengthen or shorten the top link to set the machine horizontally during work. Also, insufficient machine side-to-side stabilization can cause this. Adjust the stabilizers of the lower links to prevent machine side-to-side or up-and-down movements.
What to do if my KUHN Tiller has important ground projections to the rear?
If there are important ground projections to the rear, it may be due to incorrect hood positioning. Adjust the hood position to resolve this.
How to fix ridging across the path width with my KUHN EL22 Tiller?
Ridging across the path width can be caused by tractor-machine unit swaying. To fix this, modify one or several adjustment parameters: reduce ground speed, increase working depth, or adjust hood position.
What to do if my KUHN EL22 has a noisy drive when lifting the machine?
A noisy drive when lifting the machine may be due to a badly positioned or adjusted top link of the 3-point hitch. Position the top link parallel to the lower links. It can also be caused by excessive lifting height. Limit the lift linkage stroke to resolve this.
What to do if my KUHN Tiller has an irregular mix of plant residues?
If there is an irregular mix of plant residues, the working depth might be insufficient. Set and control the working depth to correct this issue.
General safety instructions and warnings for machine operation.
Measures for safe operation, driving, and pre-use checks.
Information on required safety equipment for road transport.
Detailed technical data including dimensions, power, and weight.
Step-by-step guide for attaching and detaching the machine from the tractor.
Instructions for preparing the tractor and adjusting linkage for machine attachment.
Guidance on PTO shaft connection, adjustment, and torque limiter function.
To Next Page
General
