KUHN EL22 - Machine Preparation and Linkage

Putting into service
Rotary cultivators
EL22
21

Preparing the machine
Axial or offset working position
Axial working position:
Offset working position:
Offset adjustment
lower links
- Loosen screw (1).
- Unscrew the 4 nuts (3).
- Slide lower coupling yoke (4) to the required position.
- Tighten the 4 nuts (3).
• Torque: 8.5 daN m (63 lbf ft).
- Adjust sliding guard (2) position to fully cover machine
front part between lower coupling yokes and machine
ends:
- Distance D between sliding guard and lower coupling
yokes must not exceed 60 mm (2.4’’).
- Tighten screw (1).
• Torque: 8.5 daN m (63 lbf ft).
- Proceed the same way on the other side.
EL 22-120
Lateral offset: L = 100 mm (3.94’’).
EL 22-150
Slight offset is possible.
Park the machine on an even fairly level
ground.