Why is my KUHN EL23 Farm Equipment requiring excessive power in dry conditions?
Excessive power requirement in dry working conditions for your KUHN Farm Equipment can be due to a working depth that is too deep, so set and control the working depth. It can also be caused by incorrect hood positioning, so adjust the hood position.
Why is my KUHN EL23 requiring excessive power in very wet conditions?
Excessive power requirement in very wet working conditions for your KUHN Farm Equipment can occur if the working depth is too deep. To resolve this, set and control the working depth. Also, excessively worn tools can cause this problem, so replace the whole set of tools to ensure rotor balance.
What to do if I see important ground projections to the rear of my KUHN Farm Equipment?
If you observe significant ground projections to the rear of your KUHN Farm Equipment, it's likely due to incorrect hood positioning. Adjust the hood position to correct this issue.
How to fix noisy drive during work with KUHN EL23?
A noisy drive during work with KUHN Farm Equipment may occur if the machine is tilted excessively to the front or rear. You should lengthen or shorten the top link to set the machine horizontally during work. Another cause could be insufficient machine side-to-side stabilization. Adjust the stabilizers of the lower links to prevent machine side-to-side or up and down movements.
How to fix noisy drive when lifting KUHN Farm Equipment?
A noisy drive when lifting KUHN Farm Equipment can be caused by a badly positioned or adjusted top link of the 3-point hitch. Position the top link parallel to the lower links to solve this. It can also be caused by excessive lifting height, so limit the lift linkage stroke.
What to do if the tilth is too coarse when using KUHN EL23?
If the tilth is too coarse when using KUHN Farm Equipment, it could be due to excessive ground speed. Reduce the ground speed to improve the tilth. Also, incorrect hood positioning can cause this, so adjust the hood position.
What causes irregular mix of plant residues with KUHN EL23 Farm Equipment and how to solve it?
An irregular mix of plant residues with KUHN Farm Equipment may be caused by insufficient working depth. Set and control the working depth to ensure proper mixing.
What causes ridging across the path width with KUHN EL23?
Ridging across the path width with KUHN Farm Equipment can be caused by tractor-machine unit swaying. To address this, modify one or several adjustment parameters: reduce ground speed, increase working depth, and adjust hood position.
General| Brand | KUHN |
|---|---|
| Model | EL23 |
| Category | Farm Equipment |
| Language | English |
To Next Page
