Kukirin G3 Pro - Error Code; Maintenance

ERROR CODE
There are warning lights flashing, and the value displays E001-E017 and flashes
Fault code Solution
a I [vor rio Frome oar ot: Woacalcs Ses I this ade nll armesis
Roar motor haul fault E-001 . If it still appears, the controller is faulty. Replace the controller and
[ery again; i it does not appear, replace the motor and try again.
Tum handlebar faut | E-002|Try again after changing the tore.
Controller faut £-003 ry again after changing the controller.
Under-voltage. | E-005 |The battery is low, try again after charging.
E CE] Te failure, please =
Recoive fault Eo ns a
: ee
Sere ro E007 eating the matrumert controle
Controller over F-009 |The temperature of the controller = too High: check whether The
temperature protection controller is fixed/heated well.
[ior fon Sr 80 iy 1880510 926 Mis ute ml iyaw's
Front motor haul fault E-011] If it still appears, the controller is faulty. Replace the controller and.
[try again: if it does not appear. replace the motor and try again.
‘Secondary controller failure | E-013 [Try again afterchanging the controller
Seb cortotr revso Tole] E017 [Bes to Eo Fran sand Talks, ry gas ate repay
2
17.MAINTENANCE
LUBRICANT 4)
Every six months, you need to add a small amount of white grease or lubricant to the folded part
for maintenance. Please check the scooter every three months to see if there are any loose
screws. If they are loose, please tighten them.
BATTERY
When you get the electric scooter for the first time, please fully charge the battery before
using it. The battery can be charged at any time to ensure that the battery has electricity.
During this period, charging will not cause any damage to the battery. When the battery is
“not in use, please use it for 3 months charge once.
=
STORE AND DAILY CARE i
Please do not leave the scooter in the hot sun or other severely damp places for a long time.
Please keep the scooter surface is clean.