Kunbus FNL Series User Manual

FNL 23 / 31
Adjustment of the operation mode (AutoSlaveMode)
In DPAutoSlaveMode FNL will start up after a reboot as an active
PROFIBUS DP Slave device with the adjusted PROFIBUS address
in DPAutoslaveAddress. FNL will detect the PROFIBUS Baud rate
automatically and accepts the I/O configuration set by the
PROFIBUS DP Master.
Illustration11: FNL DPAutoSlaveMode
This option is only available from firmware version
2.19.14. Please contact KUNBUS support if you need to
update the firmware.
Configure FNL

Kunbus FNL Series Specifications

General

Brand	Kunbus
Model	FNL Series
Category	Gateway
Language	English