Need help?Do you have a question about the KUNTENG KT-LCD4 and is the answer not in the manual?
General| Brand | KUNTENG |
|---|---|
| Model | KT-LCD4 |
| Category | Bicycle Accessories |
| Language | English |
Provides detailed measurements and a visual representation of the KT-LCD4 meter's physical dimensions.
Details the primary material (PC) and housing color (black) used for the KT-LCD4 meter.
Illustrates the connection diagram for the meter's wiring to the controller.
Shows how to install the meter on handlebars with a 22.2mm diameter.
Visual guide for the physical mounting of the meter onto the bicycle handlebars.
Covers speed, distance, throttle, PAS, battery, and brake status displays.
Details 6KM/H push assist, cruise control, and backlight/headlight controls.
Includes data clearing, fault code display, and user parameter settings.
Covers automatic voltage identification (24V, 36V, 48V) and compatibility.
Instructions for powering the meter and controller on and off, including auto-shutoff.
Details on how to start the meter and enter the initial display mode.
Setting the maximum speed limit for the e-bike; motor stops if exceeded.
Specifying the bicycle's wheel diameter for accurate speed and distance readings.
Selection of units for speed and mileage (Km/h, MPH, Km, Mil).
Procedure to save settings and exit the general project configuration.
Sets motor characteristic parameters (e.g., gear reduction ratio x magnet pieces).
Configures the number of pulses per wheel revolution for speed detection.
Selects the mode for power assist control (e.g., imitation torque or speed control).
Determines if the throttle requires foot power assist to activate ('non-zero startup').
Configures how the meter monitors and displays battery power (voltage or smart power).
Selects the power-assist sensor type and related parameters.
Identifies motor phases for sine wave drive compatibility.
Sets the default power assist gear or restores the last used gear.
Configures various throttle behaviors, including speed limits and startup modes.
Adjusts the controller's maximum operating current for performance tuning.
Sets the brightness level for the meter's backlight.
Enables or disables the cruise control function.
Configures the display of the motor's operating temperature.
Sets a password to protect the meter from unauthorized use.
Resets all meter parameters to their factory default values.
Selects communication protocol version and data source attributes.
Adjusts the minimum voltage threshold for controller operation.
Configures ABS braking strength and energy recovery parameters.
Fine-tunes the power assist levels for different riding conditions.
Sets under-voltage protection behavior for automatic under-voltage controllers.
Configures parameters for super high-speed motor controllers, used with P1.
Selects operating mode for dual mode controllers based on Hall sensor status.
Procedure to save settings and exit the parameter configuration environment.
Wiring diagram illustrating the connections for copying meter parameters.
Details on the specific wiring cable required for parameter copying.
Shows the display interface upon successful completion of parameter copying.
To Next Page
