Service Manual 10
For internal use only
3. Installation
3.1 Disposing of the packaging and your old appliance
The packaging material for transport is fully recyclable.Recycling the packaging saves raw materials and
reduces the amount of waste. Disposed appliances still contain useful materials. Take your old appliance
to a recycling collection point. Please make your old appliances unserviceable before disposing of it, to
prevent it from misuse.
3.2 Before installation
• Check that the input voltage indicated on the characteristics plate is the same as the voltage of the
power outlet you are going to use.
• Open the oven door and take out all the accessories and remove the packing material.
• Do not remove the mica cover on the ceiling of the interior! This cover prevents fat and pieces of food
from damaging the microwave generator.
• Warning! The front surface of the oven may be wrapped with a protective film. Before using the oven
for the first time, carefully remove this film, starting on the inside.
• Make sure that the oven is not damaged in any way. Check that the oven door closes correctly and
that the interior of the door and the front of the oven opening are not damaged.
• Put the oven on a flat and stable surface. The oven must not be put close to any heat sources, radios
or televisions. During installation, make sure that the power cable does not come into contact with
any moisture or objects with sharp edges behind the oven. High temperatures can damage the
cable.
Warning!
After the oven is installed you must make sure you can access the plug.
To Next Page
Loading...
Need help?
General
