Need help?Do you have a question about the Kuppersbusch GKS 324.0-54 and is the answer not in the manual?
General| Type | Gas Hob |
|---|---|
| Number of Cooking Zones/Burners | 4 |
| Width | 54 cm |
| Material | Stainless Steel |
| Ignition Type | Automatic |
| Safety Features | Flame Failure Safety Device |
Technical specifications and features of the GKS 644.0 model, including burner types, ignition, and dimensions.
Technical specifications and features of the GKS 324.0-54 model, including burner types, ignition, and dimensions.
Diagram illustrating the components of the GKS 644.0-54 hob with numbered labels for identification.
Diagram illustrating the components of the GKS 324.0-54 hob with numbered labels for identification.
Critical requirements for safe installation, including room ventilation, worktop preparation, clearances, and material compatibility.
Guidelines on combining with other Küppersbusch appliances and consequences of disregarding instructions.
Detailed diagrams showing required cut-out and overall dimensions for hob installation.
Step-by-step procedure for installing the hob, including gasket seating and sealing.
Exploded view illustrating the parts of the GKS 644.0-54 hob for identification and service.
Exploded view illustrating the parts of the GKS 324.0-54 hob for identification and service.
Instructions on how to safely remove the hob from the worktop to access internal parts.
Step-by-step guide for replacing the temperature sensors within the hob.
Step-by-step guide for replacing the spark plug components.
Instructions for replacing magnet insets located in the gas tap assembly.
Detailed procedure for replacing the gas tap assembly on the cooking zones.
Identifies accessory kit part numbers for converting the hob to various gas types.
Instructions for dismantling the hob and replacing the main injectors for gas conversion.
Step-by-step guide for replacing the low-flame injectors.
Procedures for reassembling the hob after component replacement.
Steps for correctly re-installing the hob into the worktop after servicing.
Procedures to ensure the hob operates correctly after assembly or conversion.
Table detailing injector sizes required for different gas types and burners.
Lists approved gas types and their operating pressures per country.
Details burner input power and gas consumption rates for different gas types.
Provides caloric values for various gas types according to EN 437 standard.
Specifies the acceptable inlet pressure ranges for different gas types.
Guidance on selecting appropriate pot sizes for efficient cooking and energy saving.
Instructions for proper cleaning and maintenance of the hob and its components.
Specific cleaning advice for burner covers and saucepan supports.
To Next Page